EVAL5987A [STMICROELECTRONICS]

3 A step-down switching regulator demonstration board based on the L5987, L5987A; 3一个降压型开关稳压器演示板基础上, L5987 , L5987A
EVAL5987A
型号: EVAL5987A
厂家: ST    ST
描述:

3 A step-down switching regulator demonstration board based on the L5987, L5987A
3一个降压型开关稳压器演示板基础上, L5987 , L5987A

稳压器 开关
文件: 总6页 (文件大小:286K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
EVAL5987  
EVAL5987A  
3 A step-down switching regulator demonstration board  
based on the L5987, L5987A  
Data brief  
Features  
3 A DC output current  
2.9 V to 18 V input voltage  
Output voltage adjustable from 0.6 V to 16 V  
250 kHz switching frequency, programmable  
up to 1 MHz  
Internal soft-start and inhibit  
Low dropout operation: 100% duty cycle  
Zero-load current operation  
Overcurrent and thermal protection  
VFQFPN8 3 mm x 3 mm package or HSOP8  
!-ꢀꢁꢂꢀꢃVꢂ  
for the L5987A  
Description  
The compensation network on the demonstration  
board allows the use of MLCC as output filter to  
keep the loop stable. The inductor saturation  
current and forward current of the Schottky diode  
are within the current limit values.  
The EVAL5987/A demonstration board provides  
the design engineer with a fully functional step-  
down switching regulator with an output current of  
up to 3 A. The board integrates  
STMicroelectronics’ L5987/A step-down switching  
regulator, together with all the external  
The switching frequency on the demonstration  
board is set to 500 kHz by means of the R5  
resistor connected to pin Fsw.  
components required for a typical application.  
The rated voltage of the input capacitor and the  
Schottky diode rectifier repetitive peak reverse  
voltage are both 25 V, making the board capable  
of covering the entire 2.9 V - 18 V input voltage  
range of the L5987/A device.  
The board features an external resistor divider  
(R1 and R2) designed for an output voltage  
of 1.8 V.  
The output voltage can be set to a level from 0.6 V  
up to the input voltage.  
November 2009  
Doc ID 16613 Rev 1  
1/6  
For further information contact your local STMicroelectronics sales office.  
www.st.com  
6
EVAL5987/A application circuit and component list  
EVAL5987 - EVAL5987A  
1
EVAL5987/A application circuit and component list  
Figure 1.  
Application circuit  
,ꢂ ꢄꢉꢁU( -33ꢂꢀꢈꢅ  
6INꢌꢁꢉꢃ6 ꢍ ꢂꢅ6  
6OUTꢌꢂꢉꢅ6  
6##  
).(  
/54  
#ꢁ  
ꢁꢁU  
ꢁꢄ6  
#ꢂ  
ꢁꢁU  
ꢁꢄ6  
#ꢋ  
ꢁꢁꢀN  
ꢁꢄ6  
$ꢂ  
3403ꢁ,ꢁꢄ  
,ꢄꢃꢅꢆꢇ!  
39.#(  
&"  
'.$  
&37  
#/-0  
2ꢄ  
ꢂꢄꢀK  
2ꢊ  
ꢁ+  
2ꢂ ꢊꢉꢃꢃ+  
#ꢊ ꢂꢀH&  
2ꢈ  
ꢈꢈꢀ  
2ꢁ  
ꢁꢉꢊꢃK  
#ꢄ ꢈꢈꢀP&  
#ꢈ ꢁꢉꢁN&  
!-ꢀꢁꢂꢂꢀVꢂ  
Figure 2.  
Package  
6&1&0.ꢀ ꢁXꢁ MM  
(3/0ꢀ EXPOSED PAD  
!-ꢀꢁꢂꢂꢂVꢂ  
Table 1.  
Component list  
Part number  
Reference  
Description  
Manufacturer  
C1  
C2  
C3  
C4  
C5  
C6  
R1  
R2  
R3  
R4  
R5  
L1  
GRM32ER61E226KE15  
22 µF, 25 V  
22 µF, 25 V  
Murata  
Murata  
GRM32ER61E226KE15  
2.2 nF, 50 V  
10 nF, 50 V  
330 pF, 50 V  
220 nF, 25 V  
4.99 kΩ, 1%, 0.1 W 0603  
2.49 kΩ, 1%, 0.1 W 0603  
330 Ω, 1%, 0.1 W 0603  
2 kΩ, 1%, 0.1 W 0603  
100 kΩ, 1%, 0.1 W 0603  
5.2 µH, 30%, 5.28 A  
2 A, 25 V  
MSS1038-522NL  
STPS2L25V  
Coilcraft  
D1  
STMicroelectronics  
2/6  
Doc ID 16613 Rev 1  
EVAL5987 - EVAL5987A  
PCB layout  
2
PCB layout  
Figure 3.  
PCB layout (component side)  
Figure 4.  
PCB layout (bottom side)  
Figure 5.  
PCB layout (front side)  
Doc ID 16613 Rev 1  
3/6  
Package mechanical data  
EVAL5987 - EVAL5987A  
3
Package mechanical data  
In order to meet environmental requirements, ST offers these devices in different grades of  
®
ECOPACK packages, depending on their level of environmental compliance. ECOPACK®  
specifications, grade definitions and product status are available at: www.st.com.  
®
ECOPACK is an ST trademark.  
4/6  
Doc ID 16613 Rev 1  
EVAL5987 - EVAL5987A  
Revision history  
4
Revision history  
Table 2.  
Date  
04-Nov-2009  
Document revision history  
Revision  
Changes  
1
Initial release  
Doc ID 16613 Rev 1  
5/6  
EVAL5987 - EVAL5987A  
Please Read Carefully:  
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the  
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any  
time, without notice.  
All ST products are sold pursuant to ST’s terms and conditions of sale.  
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no  
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.  
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this  
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products  
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such  
third party products or services or any intellectual property contained therein.  
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED  
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED  
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS  
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.  
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT  
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING  
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,  
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE  
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.  
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void  
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any  
liability of ST.  
ST and the ST logo are trademarks or registered trademarks of ST in various countries.  
Information in this document supersedes and replaces all information previously supplied.  
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.  
© 2009 STMicroelectronics - All rights reserved  
STMicroelectronics group of companies  
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -  
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America  
www.st.com  
6/6  
Doc ID 16613 Rev 1  

相关型号:

EVAL6207N

PractiSPIN evaluation system configuration and set up guide
STMICROELECTR

EVAL6208N

DMOS DRIVER FOR BIPOLAR STEPPER MOTOR
STMICROELECTR

EVAL6208Q

Stepper motor driver mounting the L6208Q
STMICROELECTR

EVAL6235Q

3-phase BLDC motor driver mounting the L6235Q
STMICROELECTR

EVAL6470H

dSPIN fully integrated microstepping motor driver with motion engine and SPI
STMICROELECTR

EVAL6474H

Stepper motor driver mounting the L6474
STMICROELECTR

EVAL6482H

High power microstepping motor driver with the L6482H
STMICROELECTR

EVAL6561-80

POWER FACTOR CORRECTOR
STMICROELECTR

EVAL6563-400W

L6563 400 W FOT-controlled PFC pre-regulator
STMICROELECTR

EVAL6563-80W

L6563 80W High performanceTM PFC with active tracking boost function
STMICROELECTR

EVAL6569

THE L6569 A NEW HIGH VOLTAGE IC DRIVER FOR ELECTRONIC LAMP BALLAST
PANASONIC

EVAL6902D

L6902D 1A Constant current battery charger evaluation board
STMICROELECTR