TFS168A [VECTRON]
Filter specification; 过滤器规格型号: | TFS168A |
厂家: | Vectron International, Inc |
描述: | Filter specification |
文件: | 总5页 (文件大小:225K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
Filename: tfs 168a.doc
Version 1.4
02.05.2005
VI TELEFILTER
Filter specification
TFS 168A
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
23
0
°C
dBm
121 Ω || -33 pF
Output:
133 Ω || -21.6 pF
Characteristics
Remark:
Reference level for the relative attenuation a
of the TFS 168A is the minimum of the pass band attenuation a
. The minimum of the pass band
min
rel
attenuation a
is defined as the insertion loss a . The centre frequency f is the arithmetic mean value of the upper and lower frequencies at the 1 dB
min
filter attenuation level relative to the insertion loss a . The nominal frequency f is fixed at 168,50 MHz without tolerance. The given values for the relative
e c
e
N
attenuation a
and for the group delay ripple have to be reached at the frequencies given below even if the centre frequency f is shifted due to the
rel
c
temperature coefficient of frequency TC in the operating temperature range and due to a production tolerance for the centre frequency f .
f
c
D a t a
typ. value
tolerance / limit
Insertion loss
a
8,7
dB
max.
10
dB
e
(reference level)
Nominal frequency
fN
-
168.5
-
MHz
fC
168.5
MHz
MHz
dB
Centre frequency
Passband
23,3
0,3
fN
±
10
MHz
dB
Pass band ripple
max.
1
Relative attenuation
a
rel
fN
... fN
±
10
MHz
0,3
dB
max.
1
dB
fN
fN
fN
fN
fN
-
167
21,5
81,5
141,5
241,5
MHz ... fN
MHz ... fN
MHz ... fN
MHz ... fN
MHz ... fN
-
19,5
81,5
141,5
241,5
831,5
MHz
MHz
MHz
MHz
MHz
41
39
60
60
65
dB
dB
dB
dB
dB
min.
min.
min.
min.
min.
33
33
50
50
50
dB
dB
dB
dB
dB
+
+
+
+
+
+
+
+
Group delay ripple within PB
Input power level ***
35
ns
max.
max.
100
20
ns
dBm
Operating temperature range
Storage temperature range
OTR
-
-
-20 °C .. + 80 °C
-40 °C .. + 125 °C
-
TC **
f
-87
ppm/K
Temperature coefficient of frequency
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) ∆f (Hz) = Tcf(ppm/K) x (T - To) x fCAT (MHz).
c
***) This power level is allowed for short term operation (<100 hours) only, the max. input power for continuous operation is 5 dBm.
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 168a.doc
Version 1.4
02.05.2005
VI TELEFILTER
Filter specification
TFS 168A
2/5
Filter characteristic
0
0
-1
1.105
1.03
-6
-12
-18
-24
-30
-36
-42
-48
-54
-60
-2
0.955
0.88
-3
-4
0.805
0.73
-5
0.655
0.58
-6
-7
-8
0.505
0.43
-9
-10
0.355
109
121
133
145
157
169
181
193
205
217
229
154 157 160 163 166 169 172 175 178 181 184
frequency in MHz
frequency in MHz
Construction and pin connection
(All dimensions in mm)
1
2
3
4
5
6
7
8
Ground
Input RF Return
Input
Ground
Ground
Output RF Return
Output
Ground
7
5
168A
● T19
1
3
3
Date code
1
Date code: Year + week
T
2005
2006
2007
U
V
...
7
5
1,1
2,54
50 Ohm Test circuit
L1
L2
3
7
SAW
L2
C2
1, 4, 5, 8
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 168a.doc
Version 1.4
02.05.2005
VI TELEFILTER
Filter specification
TFS 168A
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
4. Resistance to
solder heat (reflow):
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 – 3, with exeption of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters peer reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
3000
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
P1
P2
Po
PIN Marker
t
Do
Ko
Date Code
Typ
D1
Ao
W
2
Reel (all dimensions in mm)
A
:330
W1
: 12,4 +2/-0
W2(max) : 18,4
N(min)
C
: 50
: 13,0 +0,5/-0,2
C
A
N
W
1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 168a.doc
Version 1.4
02.05.2005
VI TELEFILTER
Filter specification
TFS 168A
4/5
Air reflow temperature conditions
Conditions
Exposure
Average ramp-up rate (30°C to 217°C)
> 100°C
less than 3°C/second
between 300 and 600 seconds
> 150°C
> 217°C
Peak temperature
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
Time / s
max. 300 s
10 ... 30 s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 168a.doc
Version 1.4
02.05.2005
VI TELEFILTER
Filter specification
TFS 168A
5/5
History
Version
1.0
Reason of Changes
Name
Chilla
Chilla
Date
Generation of “Development specification” according to customer requirements
11.02.2004
11.06.2004
1.1
created Filter specification
added termination impedance
added typical values
added filter characteristics
changed construction
added test circuit
changed packing
1.2
1.3
changed pin connection
Chilla
Chilla
29.07.2004
03.02.2005
added / changed limit line for 50dB and 60 dB attenuation
added typical values, reflow profile updated
1.3
changed filter specification
Chilla
02.05.2005
changed terminating impedance
changed typical values
changed limit line for 60 dB attenuation
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: tft@telefilter.com
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
相关型号:
©2020 ICPDF网 联系我们和版权申明