PLL602-13OC [PLL]

192MHz - 400MHz Low Phase Noise PECL XO (12 - 25MHz Crystal); 192MHz - 400MHz的低相位噪声PECL XO ( 12 - 25MHz晶振)
PLL602-13OC
型号: PLL602-13OC
厂家: PHASELINK CORPORATION    PHASELINK CORPORATION
描述:

192MHz - 400MHz Low Phase Noise PECL XO (12 - 25MHz Crystal)
192MHz - 400MHz的低相位噪声PECL XO ( 12 - 25MHz晶振)

石英晶振
文件: 总5页 (文件大小:198K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
PLL602-13  
192MHz – 400MHz Low Phase Noise PECL XO (12 – 25MHz Crystal)  
FEATURES  
PIN CONFIGURATION  
Low phase noise output for the 192MHz to  
400MHz range (-134 dBc at 10kHz offset).  
PECL output.  
12 to 25MHz crystal input.  
Integrated crystal load capacitor: no external  
load capacitor required.  
Output Enable selector.  
3.3V operation.  
VDD  
VDD  
XIN  
1
2
3
4
5
6
7
8
16  
15  
14  
13  
12  
11  
10  
9
VDD  
GND_BUF  
CLKBAR  
VDD_BUF  
CLK  
XOUT  
OE^  
N/C  
GND_BUF  
GND  
Available in 16 Pin TSSOP.  
GND  
GND  
GND  
Note: ^ denotes internal pull up  
FOUT = FXIN x 16  
DESCRIPTION  
The PLL602-13 is a monolithic low jitter and low  
phase noise (-134dBc/Hz @ 10kHz offset) XO IC  
with PECL output, for 192MHz to 400MHz output  
range. It provides a low phase noise reference  
frequency using a low cost crystal.  
The chip delivers an output frequency of FXIN x 16.  
This makes the PLL602-13 ideal for a wide range of  
applications.  
OE (Pin 5)  
Output State  
Tri-state  
0
1 (Default)  
Output enabled  
BLOCK DIAGRAM  
VCO  
Divider  
CLKBAR  
CLK  
Reference  
Divider  
Phase  
Charge  
Pump  
Loop  
Filter  
VCO  
OE  
Comparator  
XIN  
XOUT  
XTAL  
OSC  
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 1  
PLL602-13  
192MHz – 400MHz Low Phase Noise PECL XO (12 – 25MHz Crystal)  
PIN DESCRIPTIONS  
Name  
Number  
Type  
Description  
VDD  
XIN  
1,2,16  
P
I
Power supply.  
3
4
Crystal input. See Crystal Specifications on page 2.  
Crystal output. See Crystal Specifications on page 2.  
XOUT  
I
Output enable input. Disables (tri-state) output when low. Internal pull-up  
enables output by default if pin is not connected to low.  
OE  
5
I
N/C  
GND  
6
7,8,9,10  
11,15  
12  
-
Not connected.  
P
P
O
P
O
Ground.  
GND_BUF  
CLK  
Ground for output buffers.  
True clock output.  
VDD_BUF  
CLKB  
13  
Power supply for output buffers.  
Complementary clock output.  
14  
ELECTRICAL SPECIFICATIONS  
1. Absolute Maximum Ratings  
PARAMETERS  
SYMBOL  
MIN.  
MAX.  
UNITS  
Supply Voltage  
VDD  
VI  
4.6  
VDD+0.5  
VDD+0.5  
150  
V
Input Voltage, dc  
-0.5  
-0.5  
-65  
V
Output Voltage, dc  
VO  
TS  
TA  
TJ  
V
Storage Temperature  
°C  
°C  
°C  
°C  
kV  
Ambient Operating Temperature*  
Junction Temperature  
-40  
85  
125  
Lead Temperature (soldering, 10s)  
ESD Protection, Human Body Model  
260  
2
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the  
device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other  
conditions above the operational limits noted in this specification is not implied.  
* Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only.  
2. Crystal Specifications  
PARAMETERS  
SYMBOL  
CONDITIONS  
MIN.  
TYP.  
MAX.  
UNITS  
Crystal Resonator Frequency  
Crystal Loading Rating  
Recommended ESR  
FXIN  
CL (xtal)  
RE  
Parallel Fundamental Mode  
12  
25  
MHz  
pF  
20  
AT cut  
30  
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 2  
PLL602-13  
192MHz – 400MHz Low Phase Noise PECL XO (12 – 25MHz Crystal)  
3. General Electrical Specifications  
PARAMETERS  
SYMBOL  
CONDITIONS  
MIN.  
TYP.  
MAX.  
UNITS  
Supply Current, Dynamic  
(with Loaded Outputs)  
IDD  
PECL  
80  
mA  
Operating Voltage  
VDD  
2.97  
45  
3.63  
55  
V
%
Output Clock Duty Cycle  
Short Circuit Current  
@ VDD – 1.3V (PECL)  
50  
mA  
±50  
4. Jitter and Phase Noise Specification  
PARAMETERS  
Period jitter RMS  
CONDITIONS  
MIN.  
TYP.  
MAX.  
UNITS  
With capacitive decoupling  
between VDD and GND.  
With capacitive decoupling  
between VDD and GND. Over  
10,000 cycles.  
5
ps  
ps  
Accumulated jitter RMS  
11  
Phase Noise relative to carrier  
Phase Noise relative to carrier  
Phase Noise relative to carrier  
Phase Noise relative to carrier  
311MHz @100Hz offset  
311MHz @1kHz offset  
311MHz @10kHz offset  
311MHz @100kHz offset  
-90  
dBc/Hz  
dBc/Hz  
dBc/Hz  
dBc/Hz  
-115  
-125  
-119  
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 3  
PLL602-13  
192MHz – 400MHz Low Phase Noise PECL XO (12 – 25MHz Crystal)  
5. PECL Electrical Characteristics  
PARAMETERS  
SYMBOL  
CONDITIONS  
MIN.  
MAX.  
UNITS  
Output High Voltage  
Output Low Voltage  
VOH  
VOL  
VDD – 1.025  
V
V
RL = 50 to (VDD – 2V)  
(see figure)  
VDD – 1.620  
6. PECL Switching Characteristics  
PARAMETERS  
Clock Rise Time  
Clock Fall Time  
SYMBOL  
CONDITIONS  
MIN.  
TYP.  
MAX.  
UNITS  
tr  
tf  
@20/80% - PECL  
@80/20% - PECL  
0.6  
0.5  
1.5  
1.5  
ns  
ns  
PECL Levels Test Circuit  
PECL Output Skew  
OUT  
VDD  
OUT  
50  
50  
2.0V  
50%  
OUT  
tSKEW  
OUT  
PECL Transistion Time Waveform  
DUTY CYCLE  
45 - 55%  
55 - 45%  
OUT  
80%  
50%  
20%  
OUT  
tR  
tF  
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 4  
PLL602-13  
192MHz – 400MHz Low Phase Noise PECL XO (12 – 25MHz Crystal)  
PACKAGE INFORMATION  
16 PIN TSSOP ( mm )  
Symbol  
Min.  
-
Max.  
1.20  
0.15  
0.30  
0.20  
5.10  
4.50  
E
H
A
A1  
B
C
D
E
0.05  
0.19  
0.09  
4.90  
4.30  
D
A
H
L
e
6.40 BSC  
A1  
0.45  
0.75  
C
0.65 BSC  
L
B
e
ORDERING INFORMATION  
For part ordering, please contact our Sales Department:  
47745 Fremont Blvd., Fremont, CA 94538, USA  
Tel: (510) 492-0990 Fax: (510) 492-0991  
PART NUMBER  
The order number for this device is a combination of the following:  
Device number, Package type and Operating temperature range  
PLL602-13 X C  
TEMPERATURE  
C=COMMERCIAL  
I=INDUSTRAL  
PART NUMBER  
PACKAGE TYPE  
O=TSSOP  
Order Number  
Marking  
Package Option  
PLL602-13OC  
PLL602-13OC-R  
P602-13OC  
P602-13OC  
TSSOP – Tube  
TSSOP - Tape and Reel  
PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information  
furnished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said  
information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.  
LIFE SUPPORT POLICY: PhaseLink’s products are not authorized for use as critical components in life support devices or systems without the  
express written approval of the President of PhaseLink Corporation.  
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 5  

相关型号:

PLL602-13OI

192MHz - 400MHz Low Phase Noise PECL XO (12 - 25MHz Crystal)
PLL

PLL602-14

192MHz - 400MHz Low Phase Noise LVDS XO (12 - 25MHz Crystal)
PLL

PLL602-14OC

192MHz - 400MHz Low Phase Noise LVDS XO (12 - 25MHz Crystal)
PLL

PLL602-14OC-R

192MHz - 400MHz Low Phase Noise LVDS XO (12 - 25MHz Crystal)
PLL

PLL602-14OI

192MHz - 400MHz Low Phase Noise LVDS XO (12 - 25MHz Crystal)
PLL

PLL602-20

200MHz XO IC With Selectable 4X/8X Multiplier
PLL

PLL602-20SC

200MHz XO IC With Selectable 4X/8X Multiplier
PLL

PLL602-20SC-R

200MHz XO IC With Selectable 4X/8X Multiplier
PLL

PLL602-20SI

200MHz XO IC With Selectable 4X/8X Multiplier
PLL

PLL602-20SI-R

200MHz XO IC With Selectable 4X/8X Multiplier
PLL

PLL602-30

750kHz - 800MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
PLL

PLL602-30DC

750kHz - 800MHz Low Phase Noise XO (for 12 - 25MHz Crystals)
PLL