PSMPS-30-15 [WALL]
Single Output Up to 30 Watts AC/DC Medical Power Supply; 单路输出高达30瓦AC / DC医疗电源
| 型号： | PSMPS-30-15 |
| 厂家： | 
WALL INDUSTRIES,INC. |
| 描述： | Single Output Up to 30 Watts AC/DC Medical Power Supply |
| 文件： | 总3页 (文件大小：168K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
PSMPS30 Series
Single Output
Up to 30 Watts
FEATURES
● Low Cost
● High Reliability
● 3 Year Warranty
● Low Leakage Current 0.3mA
● Universal AC Input / Full Range
● Fixed Switching Frequency at 100KHz
● Protections: Short Circuit /Overload /Over Voltage /Over Temperature
SPECIFICATIONS: PSMPS30 Series
All specifications are based on 25oC, Nominal Input Voltage, and Maximum Output Current unless otherwise noted.
We reserve the right to change specifications based on technological advances.
INPUT SPECIFICATIONS
Input Voltage
88 – 264VAC auto switch (127 – 370VDC)
47 to 63Hz
Input Frequency
AC Current (typical)
Inrush Current
Leakage Current
0.8A @ 115VAC / 0.5A @ 230VAC
30A @ 230VAC cold start
Less than 0.3mA @ 264VAC
OUTPUT SPECIFICATIONS
Output Voltage
See Table
Output Voltage Tolerance
Output Power
±3% for all models except PSMPS-30-48 (±2%)
See Table
±1% max.
Line Regulation
Load Regulation
±1% for all models except PSMPS-30-5 (±2%)
See Table
See Table
500ms and 30ms @ 230VAC and full load / 500ms and 30ms @ 115VAC and full load
70ms @ 230VAC and full load / 12 ms @ 115VAC and full load.
±0.03%/°C (0~50°C)
Output Current
Ripple & Noise (20MHz BW)
Setup, Rise Time
Hold-Up Time
Temperature Coefficient
PROTECTION
Over Voltage Protection
Protection Type: Shutdown output voltage, re-power on to recover
Above 105% rated output power.
Overload Protection
Protection Type: Hiccup mode, recovers automatically after fault condition is removed.
Protection Type: Shutdown output voltage, recovers automatically after temperature goes down.
Tj 135°C typically (U1) Detect on main control IC.
Over Temperature Protection
GENERAL SPECIFICATIONS
Switching Frequency (fixed)
Efficiency
100KHz
See Table
Isolation Voltage
4000VAC (Input to Output), 1500VAC (Input to FG), SHORT (Output to FG)
100MΩ / 500VDC (Input to Output), 100MΩ / 500VDC (Input to FG)
Isolation Resistance
ENVIRONMENTAL SPECIFICATIONS
Operating Temperature
Storage Temperature
Operating Humidity (non-condensing)
Storage Humidity (non-condensing)
Vibration
-10°C to +60°C (refer to derating curve)
-20°C to +85°C
20% to 90% RH
10% to 95% RH
10~500Hz, 2G 10min./1cycle, Period for 60 minutes each along X, Y, and Z axes.
547,000 hours min. (According to MIL-HDBK-217) at 25°C
MTBF
PHYSICAL SPECIFICATIONS
Weight
150g
Dimensions
101.6(L) x 65.8(W) x 23.5(H) mm
SAFETY & EMC
Safety Standards
UL2601-1, TUV EN60601-1, IEC601-1 Approved
EMI Conduction & Radiation
Harmonic Current
Compliance to EN55011 (CISPR11) Class B
Compliance to EN61000-3-2,-3
EMS Immunity
Compliance to EN61000-4-2,3,4,5,6,8,11, ENV50204, EN55024, EN60601-1-2, Medical level, criteria A
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
PSMPS30 Series
Single Output
Up to 30 Watts
OUTPUT VOLTAGE / CURRENT RATING CHART
Output
Output
Model
Input Voltage
Ripple & Noise
Output Power
Efficiency
Voltage
Current
PSMPS-30-5
PSMPS-30-12
PSMPS-30-15
PSMPS-30-24
PSMPS-30-27
PSMPS-30-48
5 VDC
12 VDC
15 VDC
24 VDC
27 VDC
48 VDC
5A
80mV
120mV
150mV
240mV
240mV
240mV
25W
30W
72%
75%
76%
77%
78%
78%
2.5A
2A
30W
88~264VAC
120~370VDC
1.2A
1.1A
0.6A
28.8W
29.7W
28.8W
NOTES
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load, and 25°C ambient temperature.
2. Ripple & noise is measured at 20MHz bandwidth by using a 12" twisted pair-wire terminated with a 0.1µf and 47µF
parallel capacitor.
3. Tolerance: includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component, which will be installed into final equipment. The final equipment must be
re-confirmed that it still meets EMC directives.
BLOCK DIAGRAM
DERATING CURVE
STATIC CHARACTERISTICS
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
PSMPS30 Series
Single Output
Up to 30 Watts
MECHANICAL DRAWING
Unit: mm
AC Input Connector (CN1): Molex 5277-02 or equivalent
DC Output Connector (CN2): Molex 41791-5 or equivalent
Pin. No
Assignment
Mating Housing
Terminal
Pin No.
Assignment
Mating Housing
Terminal
1,2
-V
1
2,4
3
FG
Molex 2139
Molex 2478
or equivalent
or equivalent
3,4
+V
No Pin
AC/N
Molex 2139
Molex 2478
or equivalent
or equivalent
5
AC/L
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
相关型号：
©2020 ICPDF网 联系我们和版权申明