TFS140AG [VECTRON]

Filter specification; 过滤器规格
TFS140AG
型号: TFS140AG
厂家: Vectron International, Inc    Vectron International, Inc
描述:

Filter specification
过滤器规格

过滤器
文件: 总5页 (文件大小:233K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
Filename: tfs 140ag.doc  
Version 1.3  
02.02.2006  
VI TELEFILTER  
Filter specification  
TFS 140AG  
1/5  
Measurement condition  
Ambient temperature:  
Input power level:  
Terminating impedance: *  
Input:  
23  
0
°C  
dBm  
333 || -9.9 pF  
326 || -10.9 pF  
Output:  
Characteristics  
Remark:  
Reference level for the relative attenuation a  
of the TFS 140AG is the minimum of the pass band attenuation a  
. The minimum of the pass band  
min  
rel  
attenuation a  
min  
is defined as the insertion loss a . The centre frequency fC is the arithmetic mean value of the upper and lower frequencies at the 1dB  
e
filter attenuation level relative to the insertion loss a . The nominal frequency f is fixed at 140,0 MHz without tolerance. The given values for the relative  
e
N
attenuation a  
and for the group delay ripple have to be reached at the frequencies given below even if the centre frequency fC is shifted due to the  
rel  
temperature coefficient of frequency TC in the operating temperature range and due to a production tolerance for the centre frequency fC.  
f
D a t a  
typ. value  
tolerance / limit  
Insertion loss  
a
9.1  
dB  
max.  
11.5  
dB  
e
(reference level)  
Nominal frequency  
Passband  
fN  
140  
-
MHz  
140  
MHz  
MHz  
dB  
PB  
p-p  
fN  
±
7,5  
Pass band ripple  
Relative attenuation  
fN  
0.2  
dB  
max.  
0.8  
a
rel  
±
... fN  
9,5  
18  
14  
18  
MHz  
0.3  
dB  
max.  
1
dB  
fN  
fN  
fN  
fN  
-
-
+
+
139  
18  
14  
MHz ... fN  
MHz ... fN  
MHz ... fN  
MHz ... fN  
-
-
+
+
MHz  
MHz  
MHz  
MHz  
45  
23  
14  
43  
dB  
dB  
dB  
dB  
min.  
min.  
min.  
min.  
37  
10  
10  
37  
dB  
dB  
dB  
dB  
18  
360  
Absolute group delay in PB**  
Group delay ripple in PB**  
Phase linearity in PB**  
Input power level ***  
524  
30  
2.5  
-
ns  
p-p  
p-p  
ns  
max.  
max.  
max.  
50  
6
ns  
deg  
deg  
dBm  
21  
Operating temperature range  
Storage temperature range  
OTR  
-
-
-25 °C..... +70 °C  
-40 °C..... +85 °C  
-
Temperature coefficient of frequency  
TC ****  
-94  
ppm/K  
f
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values  
only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.  
**) Maximum variation of the mean value measured in PB within operating temperature range.  
***) Maximum value for 10 years operation.  
****) f (Hz) = TCf(ppm/K) x (T - To) x fTo (MHz).  
c
Generated:  
Checked / Approved:  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  
Filename: tfs 140ag.doc  
Version 1.3  
02.02.2006  
VI TELEFILTER  
Filter specification  
TFS 140AG  
2/5  
Filter characteristic  
0
0
-1  
0.77  
0.74  
0.71  
0.68  
0.65  
0.62  
0.59  
0.56  
0.53  
0.5  
-6  
-12  
-18  
-24  
-30  
-36  
-42  
-48  
-54  
-60  
-2  
-3  
-4  
-5  
-6  
-7  
-8  
-9  
-10  
0.47  
70.4 84.4 98.4 112.4 126.4 140.4 154.4 168.4 182.4 196.4 210.4  
frequency in MHz  
127.4 130 132.6 135.2 137.8 140.4 143 145.6 148.2 150.8 153.4  
frequency in MHz  
Construction and pin connection  
(All dimensions in mm)  
13,6Max.  
1
2
Ground  
Ground  
3
Ground  
4
5
6
7
Ground  
Output  
Output RF Return  
Ground  
Ground  
TFS 140AG  
S41  
8
1
9
Ground  
Ground  
Input  
Input RF Return  
Date code  
10  
11  
12  
2,54 ±0,15  
1,5  
2
1
3 4  
Date code: Year + week  
12  
11  
S
T
U
...  
2004  
2005  
2006  
5
6
9 8  
10  
7
0,1  
0,8  
50 Ohm Test circuit  
L1  
11  
5
L2  
SAW  
C1  
C2  
1, 2, 3, 4, 7, 8, 9, 10  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  
Filename: tfs 140ag.doc  
Version 1.3  
02.02.2006  
VI TELEFILTER  
Filter specification  
TFS 140AG  
3/5  
Stability characteristics  
After the following tests the filter shall meet the whole specification:  
1. Shock:  
500g, 18 ms, half sine wave, 3 shocks each plane;  
DIN IEC 68 T2 - 27  
2. Vibration:  
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;  
DIN IEC 68 T2 - 6  
3. Change of  
temperature:  
-55 °C to 125°C / 30 min. each / 10 cycles  
DIN IEC 68 part 2 – 14 Test N  
4. Resistance to  
solder heat (reflow):  
reflow possible: twice max.;  
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;  
This filter is RoHS compliant (2002/95/EG, 2005/618/EG)  
Packing  
Tape & Reel:  
IEC 286 – 3, with exeption of value for N and minimum bending radius;  
tape type II, embossed carrier tape with top cover tape on the upper side;  
max. pieces of filters peer reel:  
reel of empty components at start:  
reel of empty components at start including leader:  
trailer:  
1700  
min. 300 mm  
min. 500 mm  
min. 300 mm  
Pull Off Direction  
Tape (all dimensions in mm)  
P1  
W
Po  
Do  
E
: 24,00 +0,30/-0,10  
Po  
P2  
PIN Marker  
t
Do  
:
:
:
4,00 ± 0,1  
1,50 +0,1/-0  
1,75 ± 0,10  
F
: 11,50 ± 0,10  
G(min)  
P2  
:
:
0,60  
2,00 ± 0,1  
P1  
: 12,00 ± 0,1  
D1(min)  
Ao  
:
:
1,50  
7,10 ± 0,10  
Ko  
Typ  
D1  
Date Code  
Ao  
Bo  
Ct  
: 13,90 ± 0,10  
: 21,5 ± 0,1  
W
2
Reel (all dimensions in mm)  
A
:330  
W1  
: 24,4 +2/-0  
W2(max) : 30,4  
N(min)  
C
: 60  
: 13,0 +0,5/-0,2  
C
A
N
W
1
The minimum bending radius is 45 mm.  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  
Filename: tfs 140ag.doc  
Version 1.3  
02.02.2006  
VI TELEFILTER  
Filter specification  
TFS 140AG  
4/5  
Air reflow temperature conditions  
Conditions  
Exposure  
Average ramp-up rate (30°C to 217°C)  
> 100°C  
less than 3°C/second  
between 300 and 600 seconds  
> 150°C  
> 217°C  
Peak temperature  
between 240 and 500 seconds  
between 30 and 150 seconds  
max. 260°C  
Time within 5°C of actual peak temperature  
Cool-down rate (Peak to 50°C)  
Time from 30°C to Peak temperature  
between 10 and 30 seconds  
less than 6°C/second  
no greater than 300 seconds  
Chip-mount air reflow profile  
Temperature / °C  
max. 260°C  
217°C  
Time / s  
max. 300 s  
10 ... 30 s  
30 ... 150 s  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  
Filename: tfs 140ag.doc  
Version 1.3  
02.02.2006  
VI TELEFILTER  
Filter specification  
TFS 140AG  
5/5  
History :  
Version  
Reason of Changes  
Name  
Date  
1.0  
1.1  
Generate development specification  
decreased passband  
Chilla  
Chilla  
18.06.2004  
08.09.2004  
added relative attenuation at fn+/-14MHz  
1.2  
created filter specification  
added termination impedances  
added typical values  
Chilla  
08.10.2004  
changed insertion loss  
changed passband  
changed ripple in passband  
changed frequency limit at 10 dB and 37 dB relative attenuation  
changed group delay ripple  
changed phase linearity  
added filter characteristic  
added test circuit  
1.3  
added typical values for absolute group delay  
Added comments for RoHS compliance  
Update of reflow profile  
Chilla  
02.02.2006  
Tele Filter GmbH  
Potsdamer Straße 18  
D 14 513 TELTOW / Germany  
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30  
E-Mail: tft@telefilter.com  
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is  
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.  

相关型号:

TFS140AL

Filter specification
VECTRON

TFS140AN

Filter specification
VECTRON

TFS140AP

Filter specification
VECTRON

TFS140AR

Filter specification
VECTRON

TFS140AS

Filter specification
VECTRON

TFS140AT

Filter specification
VECTRON

TFS140AU

Filter specification
VECTRON

TFS140AV

Filter specification
VECTRON

TFS140C

Filter Specification
VECTRON

TFS140D

Filter Specification
VECTRON

TFS140E

Filter Specification
VECTRON

TFS140F

Filter Specification
VECTRON