UCS1600SG-S08-R [UTC]
HIGH PERFORMANCE CURRENT MODE POWER SWITCH;型号: | UCS1600SG-S08-R |
厂家: | Unisonic Technologies |
描述: | HIGH PERFORMANCE CURRENT MODE POWER SWITCH |
文件: | 总8页 (文件大小:294K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
UNISONIC TECHNOLOGIES CO., LTD
UCS1600S
Preliminary
LINEAR INTEGRATED CIRCUIT
HIGH PERFORMANCE
CURRENT MODE POWER
SWITCH
DIP-8
DESCRIPTION
The UTC UCS1600S is an integrated PWM controller and
Power MOSFET specifically designed for switching operation with
minimal external components. The UTC UCS1600S is designed
to provide several special enhancements to satisfy the needs, for
example, Power-Saving mode for low standby power, Frequency
Hopping
,
Constant Output Power Limiting
,
Slope
SOP-8
Compensation ,Over Current Protection (OCP), Over Voltage
Protection (OVP), Over Load Protection (OLP), Under Voltage
Lock Out (UVLO), Over Temperature Protection (OTP), etc. IC
will be shutdown or can auto-restart in situations.
FEATURE
* Internal Power MOSFET (600V)
* Programming Gate Driver Capability
* Frequency hopping for Improved EMI Performance.
* Lower than 30mW Standby Power Design
* Linearly decreasing frequency to 20~35KHz during light load
* Internal Soft start
* Gate Output Maximum Voltage Clamp(16V)
* Over temperature protection
* Overload protection
* Over voltage protection
* Leading edge blanking
* Cycle-by-Cycle current limiting
* Under Voltage Lock Out
* Internal Slope Compensation
* Constant Power Limiting for universal AC input Range
ORDERING INFORMATION
Ordering Number
Lead Free
Package
Packing
Halogen Free
UCS1600SL-D08-T
UCS1600SL-S08-R
UCS1600SG-D08-T
UCS1600SG-S08-R
DIP-8
Tube
SOP-8
Tape Reel
MARKING
www.unisonic.com.tw
Copyright © 2017 Unisonic Technologies Co., Ltd
1 of 8
QW-R103-122.c
UCS1600S
Preliminary
LINEAR INTEGRATED CIRCUIT
PIN CONFIGURATION
PIN DESCRIPTION
PIN NO.
PIN NAME
VCC-G
VCC
DESCRIPTION
1
2
3
4
5
6
7
8
Supply voltage
Supply voltage
Feedback
FB
CS
Current sense input
Power MOSFET drain
Power MOSFET drain
Ground
DRAIN
DRAIN
GND
GND
Ground
UNISONIC TECHNOLOGIES CO., LTD
2 of 8
QW-R103-122.c
www.unisonic.com.tw
UCS1600S
Preliminary
LINEAR INTEGRATED CIRCUIT
BLOCK DIAGRAM
Notes: OLP (Over Load Protection)
OVP (Over Voltage Protection)
OTP (Over Temperature Protection)
OCP (Over Current Protection)
UVLO (Under Voltage Latch-Out)
LEB (Led Edge Blanking)
UNISONIC TECHNOLOGIES CO., LTD
3 of 8
QW-R103-122.c
www.unisonic.com.tw
UCS1600S
Preliminary
LINEAR INTEGRATED CIRCUIT
ABSOLUTE MAXIMUM RATING (TA=25°C, unless otherwise specified)
PARAMETER
SYMBOL
VCC
RATINGS
32
UNIT
V
Supply Voltage
Input Voltage to FB Pin
Input Voltage to CS Pin
Junction Temperature
Operating Temperature
Storage Temperature
VFB
-0.3 ~ 6.5
-0.3 ~ 6.5
+150
V
VCS
V
TJ
°C
°C
°C
TOPR
TSTG
-40 ~ +125
-50 ~ +150
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
OPERATING RANGE
PARAMETER
SYMBOL
VCC
RATINGS
10 ~ 24
51 ~ 510
10
UNIT
V
Supply Voltage
VCC-G Pin Series Resistor
VCC_GR
PO_MAX
Ω
Open Frame Output Power for 85~264VAC
W
ELECTRICAL CHARACTERISTICS (TA=25°C, VCC=15V, unless otherwise specified)
PARAMETER
SYMBOL
TEST CONDITIONS
MIN TYP MAX UNIT
SUPPLY SECTION
Start Up Current
IST
IOP
VCC =VTHD(ON)-1V
VFB=3.5V
2
15
5.5
32
μA
mA
V
Supply Current with Switch
VDD Zener Clamp Current
UNDER-VOLTAGE LOCKOUT SECTION
Start Threshold Voltage
Min. Operating Voltage
2.5
30
vCLAMP
IVDD=20mA
29
VTHD(ON)
VCC(MIN)
18
20
8
22
V
V
6.5
9.5
CONTROL SECTION
Feedback Source Current
VFB Open Loop Voltage Level
Burst-Mode Out FB Voltage
Burst-Mode Enter FB Voltage
IFB
VFB=0
240
5.4
1.8
1.6
65
uA
V
VFB_Open
VFB(OUT)
VFB(IN)
VCS =0
V
VCS =0
V
Switching
Normal Initial
VFB=3.5V
60
20
70
-9
70
kHz
kHz
%
F(SW)
Frequency
Burst Mode Base Frequency
Duty Cycle
DMAX
FJ(SW)
FDV
VFB=3.5V, VCS=0
80
90
+9
10
10
Frequency Hopping
%
Frequency Variation vs. VCC Deviation
Frequency Variation vs. Temperature Deviation
Soft-Start Time
VCC=10 ~ 20V
T=-40 ~ 110°C
%
FDT
%
TSOFTS
5
ms
PROTECTION SECTION
OVP Threshold
VOVP
VFB(OLP)
TD-OLP
T(THR)
VFB=3.5V
VCS=0
25
60
27
4.2
88
28
V
V
OLP Threshold
Delay Time Of OLP
120
ms
°C
OTP Threshold
140
CURRENT LIMITING SECTION
Leading Edge Blanking Time
Peak Current Limitation
tLEB
200
350
550
nS
V
VSENSE_H
VSENSE_L
VFB=3.9V
VFB=3.9V
0.92
Threshold Voltage For Valley
POWER MOS-TRANSISTOR SECTION
Drain-Source Breakdown Voltage
Drain-Source Diode Continuous Source Current
Static Drain-Source On-State Resistance
0.73 0.79 0.85
V
VDSS
IS
VGS=0V, ID=250μA
600
0.85
7.0
V
A
ꢀ
RDS(ON)
VGS=10V, ID=0.5A
Notes: 1. Pulse Test: Pulse width ≤ 300μs, Duty cycle ≤ 2%.
2. Essentially independent of operating temperature.
UNISONIC TECHNOLOGIES CO., LTD
4 of 8
QW-R103-122.c
www.unisonic.com.tw
UCS1600S
Preliminary
LINEAR INTEGRATED CIRCUIT
FUNCTIONAL DESCRIPTION
The internal reference voltages and bias circuit work at VCC> VTHD(ON), and shutdown at VCC<VCC(MIN)
.
(1) Soft-Start
When every IC power on, driver output duty cycle will be decided by inter-slope voltage VSOFTS and VCS on
current sense resistor at beginning. After the whole soft-start phase end, and driver duty cycle depend on VFB and
V
CS. The relation among VSOFTS, VFB and VOUT as followed Fig.3. Furthermore, soft-start phase should end before VCC
reach VCC(MIN) during VCC power on. Otherwise, if soft-start phase remain not end before VCC reach VCC(MIN) during
CC power on, IC will enter auto-restart phase and not set up VOUT
V
.
Fig.3 Soft-start phase
(2) Internal Synchronized Slope Compensation
Built-in slope compensation circuit adds voltage ramp onto the current sense input voltage for PWM generation,
this greatly improves the close loop stability at CCM and prevents the sub-harmonic oscillation and thus reduces the
output ripple voltage.
(3) Frequency Hopping For EMI Improvement
The Frequency Hopping is implemented in the IC; there are two oscillators built-in the IC. The first oscillator is to
set the normal switching frequency; the switching frequency is modulated with a period signal generated by the 2nd
oscillator. The relation between the first oscillator and the 2nd oscillator as followed Fig.4. So the tone energy is
evenly spread out, the spread spectrum minimizes the conduction band EMI and therefore eases the system design
in meeting stringent EMI requirement.
Fig.4 Frequency Hopping
UNISONIC TECHNOLOGIES CO., LTD
5 of 8
QW-R103-122.c
www.unisonic.com.tw
UCS1600S
Preliminary
LINEAR INTEGRATED CIRCUIT
FUNCTIONAL DESCRIPTION (Cont.)
(4) Constant Output Power Limit
When the primary current, across the primary wind of transformer, reaches the limit current, the output GATE
driver will be turned off after a small propagation delay tD. This propagation delay will introduce an additional current
proportional to tD×VIN/Lp. Since the propagation delay is nearly constant regardless of the input line voltage VIN.
Higher input line voltage will result in a larger additional current and hence the output power limit is also higher than
that under low input line voltage. To compensate for this output power limit variation across a wide AC input range,
the threshold voltage is adjusted by adding a positive ramp. This ramp signal rises from VSENSE-L to VSENSE_H, and
then flattens out at VSENSE_H. A smaller threshold voltage forces the output GATE drive to terminate earlier. This
reduces the total PWM turn-on time and makes the output power equal to that of low line input. This proprietary
internal compensation ensures a constant output power limit for a wide AC input voltage range (90VAC to 264VAC).
(5) Protection section
The IC takes on more protection functions such as OLP, OVP and OTP etc. In case of those failure modes for
continual blanking time, the driver is shut down. At the same time, IC enters auto-restart, VCC power on and driver is
reset after VCC power on again.
OLP
After power on, IC will shutdown driver if over load state occurs for continual TD-OLP. OLP case as followed Fig.5.
OVP
OVP will shutdown the switching of the power MOSFET whenever VCC>VOVP. The OVP case as followed Fig.6.
Fig.5 OLP case
Fig.6 OVP case
OTP
OTP will shut down driver when junction temperature TJ>T(THR) for continual a blanking time.
UNISONIC TECHNOLOGIES CO., LTD
6 of 8
QW-R103-122.c
www.unisonic.com.tw
UCS1600S
Preliminary
LINEAR INTEGRATED CIRCUIT
FUNCTIONAL DESCRIPTION (Cont.)
(6) Driver Output Section
The driver-stage drives the gate of the MOSFET and is optimized to minimize EMI and to provide high circuit
efficiency. This is done by reducing the switch on slope when reaching the MOSFET threshold. This is achieved by a
slope control of the rising edge at the driver’s output. The output driver is clamped by an internal 16V Zener diode in
order to protect power MOSFET transistors against undesirable gate over voltage.
In addition to the gate drive control scheme mentioned, the gate drive strength can also be adjusted externally
by a resistor connected between VDD and VDDG, the falling edge of the Drain output can be well controlled. It provides
great flexibility for system EMI design.
(7) Inside power switch MOS transistor
Specific power MOS transistor parameter is as “POWER MOS TRANSISTOR SECTION” in electrical
characteristics table.
UNISONIC TECHNOLOGIES CO., LTD
7 of 8
QW-R103-122.c
www.unisonic.com.tw
UCS1600S
Preliminary
LINEAR INTEGRATED CIRCUIT
TYPICAL APPLICATION CIRCUIT
Fig.7 UTC UCS1600S Typical Application Circuit
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
8 of 8
QW-R103-122.c
www.unisonic.com.tw
相关型号:
©2020 ICPDF网 联系我们和版权申明