TOCP255-20CB [TOSHIBA]
CONNECTOR, 980/1000 um, MULTI MODE, DUPLEX FIBER OPTIC CONNECTOR;型号: | TOCP255-20CB |
厂家: | TOSHIBA |
描述: | CONNECTOR, 980/1000 um, MULTI MODE, DUPLEX FIBER OPTIC CONNECTOR 光纤 连接器 |
文件: | 总3页 (文件大小:136K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
TOCP255−□□B
OPTICAL FIBER WITH FIBER OPTIC CONNECTORS
TOCP255−□□B
WITH FIBER OPTIC CONNECTORS
ALL PLASTIC FIBER
Unit: mm
ꢀ Conform to JIS F07 type
ꢀ Duplex type
ꢀ APF (980 / 000µm)
1. Maximum Ratings (Ta = 25°C)
ITEM
Storage Temperature
Operating Temperature
Between Fiber and Connector
SYMBOL
RATINGS
UNIT
T
−40 to 70
−20 to 70
19.6
°C
°C
N
stg
T
opr
T
CF
Tension
Optical Fiber
Bending Radius
T
F
98
N
r
Min 40
mm
1
2001-06-13
TOCP255−□□B
2. Optical Characteristics (Ta = 25°C)
ITEM
SYMBOL
CONDITIONS
MIN
TYP.
220
MAX
240
UNIT
λp = 650nm, Measured by fiber
Transmission Loss
―
dB / km
length 50m
3. Precautions for Operation
(1) The maximum ratings are the limit values which should not be exceeded when using this product. All
of these values must be within the defined range. If the maximum ratings, are exceeded the deviced
characteristics may not be recoverable and, in extreme cases, permanent damage to the product may
result.
Care should be taken not to exceed the maximum ratings when using this product.
(2) Care should be taken not to drop heavy objects onto the optical fiber cables.
(3) When connecting or disconnecting the optical fiber with fiber optic connector, be sure to hold the fiber
optic connector. Do not hold the optical fiber cable when connecting or disconnecting.
(4) When inserting the fiber optic connector into the fiber optic transceiving module, be sure to follow the
correct fitting alignment.
(5) Keep the end face of the optical fiber with fiber optic connector clean. If contaminated, wipe it gently
with tissue paper.
(6) When bending the optical fiber cable to install it, note that the recommended bending radius is six to
ten times longer than the minimum bending radius.
(7) −□□ indicates the length and the unit of length of the optical fiber of the optical fiber with fiber optic
connector or optical fiber products. The length of the optical fiber is the distance from one end of fiber
optic connector to the other end. The minimum fiber length is 0.2m.
EX. TOCP255−10MB
Unit of length
C: cm
M: m
Length
2
2001-06-13
TOCP255−□□B
RESTRICTIONS ON PRODUCT USE
000707EAA
• TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical
stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of
safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of
such TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as
set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and
conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability
Handbook” etc..
• The TOSHIBA products listed in this document are intended for usage in general electronics applications
(computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances,
etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires
extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or
bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or
spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments,
medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this
document shall be made at the customer’s own risk.
• The information contained herein is presented only as a guide for the applications of our products. No
responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other
rights of the third parties which may result from its use. No license is granted by implication or otherwise under
any intellectual property or other rights of TOSHIBA CORPORATION or others.
• The information contained herein is subject to change without notice.
3
2001-06-13
相关型号:
©2020 ICPDF网 联系我们和版权申明