TC74AC05F(EL) [TOSHIBA]
IC AC SERIES, HEX 1-INPUT INVERT GATE, PDSO14, 0.300 INCH, PLASTIC, SOIC-14, Gate;
| 型号： | TC74AC05F(EL) |
| 厂家： | 
TOSHIBA |
| 描述： | IC AC SERIES, HEX 1-INPUT INVERT GATE, PDSO14, 0.300 INCH, PLASTIC, SOIC-14, Gate |
| 文件： | 总8页 (文件大小：260K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
TC74AC05P/F/FN
TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic
TC74AC05P,TC74AC05F,TC74AC05FN
Hex Inverter (open drain)
Note: xxxFN (JEDEC SOP) is not available in
Japan.
The TC74AC05 is an advanced high speed CMOS INVERTER
fabricated with silicon gate and double-layer metal wiring
C2MOS technology.
TC74AC05P
It achieves the high speed operation similar to equivalent
Bipolar Schottky TTL while maintaining the CMOS low power
dissipation.
Pin configuration and function are the same as the TC74AC04,
but the TC74AC05 has high performance MOS N-channel
transistor (open-drain) outputs.
This device can, therefore, with a suitable pull-up resistors, be
used in wired-OR, LED drive and other applications.
All inputs are equipped with protection circuits against static
TC74AC05F
discharge or transient excess voltage.
Features
•
•
•
•
High speed: t = 3.4 ns (typ.) at V
= 5 V
pz
CC
Low power dissipation: I
= 4 μA (max) at Ta = 25°C
CC
High noise immunity: V
= V
= 28% V
(min)
NIH
NIL
CC
Symmetrical output impedance: I
= 24 mA (min)
OL
TC74AC05FN
Capability of driving 50 Ω
transmission lines.
•
•
•
Wide operating voltage range: V
(opr) = 2 to 5.5 V
CC
Open drain structure.
Pin and function compatible with 74F05
Pin Assignment
Weight
DIP14-P-300-2.54
SOP14-P-300-1.27A
SOL14-P-150-1.27
: 0.96 g (typ.)
: 0.18 g (typ.)
: 0.12 g (typ.)
1
2007-10-01
TC74AC05P/F/FN
IEC Logic Symbol
Truth Table
A
Y
L
Z
L
H
Z: High impedance
System Diagram (per gate)
Absolute Maximum Ratings (Note 1)
Characteristics
Supply voltage range
Symbol
Rating
Unit
V
−0.5 to 7.0
V
V
CC
DC input voltage
V
−0.5 to V
+ 0.5
IN
CC
CC
DC output voltage
Input diode current
Output diode current
DC output current
V
−0.5 to V
+ 0.5
V
OUT
I
±20
mA
mA
mA
mA
mW
°C
IK
I
±50
+50
OK
I
OUT
DC V /ground current
CC
I
±150
CC
Power dissipation
P
500 (DIP) (Note 2)/180 (SOP)
D
Storage temperature
T
stg
−65 to 150
Note 1: Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or
even destruction.
Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly
even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute
maximum ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/Derating Concept and Methods) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 2: 500 mW in the range of Ta = −40 to 65°C. From Ta = 65 to 85°C a derating factor of −10 mW/°C should be
applied up to 300 mW.
2
2007-10-01
TC74AC05P/F/FN
Operating Ranges (Note)
Characteristics
Symbol
Rating
Unit
Supply voltage
Input voltage
V
2.0 to 5.5
V
V
CC
V
0 to V
0 to V
IN
CC
CC
Output voltage
V
V
OUT
Operating temperature
T
−40 to 85
0 to 100 (V = 3.3 ± 0.3 V)
°C
opr
CC
0 to 20 (V
Input rise and fall time
dt/dV
ns/V
= 5 ± 0.5 V)
CC
Note:
The operating ranges must be maintained to ensure the normal operation of the device.
Unused inputs must be tied to either VCC or GND.
Electrical Characteristics
DC Characteristics
Ta =
−40 to 85°C
Test Condition
Ta = 25°C
Characteristics
Symbol
Unit
V
V
(V)
Min
1.50
2.10
3.85
⎯
Typ.
⎯
Max
⎯
Min
1.50
2.10
3.85
⎯
Max
⎯
CC
2.0
High-level input
voltage
V
⎯
3.0
5.5
2.0
3.0
5.5
2.0
3.0
4.5
3.0
4.5
5.5
⎯
⎯
⎯
IH
⎯
⎯
⎯
⎯
0.50
0.90
1.65
0.1
0.1
0.1
0.36
0.36
⎯
0.50
0.90
1.65
0.1
Low-level input
voltage
V
⎯
⎯
⎯
⎯
V
IL
⎯
⎯
⎯
⎯
0.0
0.0
0.0
⎯
⎯
I
= 50 μA
⎯
⎯
0.1
OL
⎯
⎯
0.1
Low-level output
voltage
V
IN
= V
V
V
OL
IH
I
I
I
= 12 mA
⎯
⎯
0.44
0.44
1.65
OL
OL
OL
= 24 mA
⎯
⎯
⎯
= 75 mA (Note)
⎯
⎯
⎯
V
V
= V
IN
IL
3-state output
off-state current
I
5.5
⎯
⎯
±0.5
⎯
±5.0
μA
OZ
= V
OUT
IN
CC
Input leakage
current
I
V
V
= V
or GND
or GND
5.5
5.5
⎯
⎯
⎯
⎯
±0.1
⎯
⎯
±1.0
μA
μA
IN
CC
CC
Quiescent supply
current
I
= V
IN
4.0
40.0
CC
Note:
This spec indicates the capability of driving 50 Ω transmission lines.
One output should be tested at a time for a 10 ms maximum duration.
3
2007-10-01
TC74AC05P/F/FN
AC Characteristics (C = 50 pF, R = 500 Ω, input: t = t = 3 ns)
L
L
r
f
Ta =
−40 to 85°C
Test Condition
Ta = 25°C
Characteristics
Symbol
Unit
V
(V)
Min
⎯
⎯
⎯
⎯
⎯
⎯
Typ.
4.1
3.5
5.9
4.1
5
Max
7.0
5.3
9.1
6.6
10
Min
1.0
1.0
1.0
1.0
⎯
Max
8.0
6.0
10.4
7.5
10
CC
3.3 ± 0.3
5.0 ± 0.5
3.3 ± 0.3
5.0 ± 0.5
Propagation delay
time
⎯
⎯
ns
ns
t
t
pLZ
pZL
Propagation delay
time
Input capacitance
Output capacitance
C
⎯
⎯
pF
pF
IN
C
10
⎯
⎯
⎯
OUT
C
PD
Power dissipation
capacitance
⎯
⎯
8
⎯
⎯
⎯
pF
(Note)
Note:
C
PD
is defined as the value of the internal equivalent capacitance which is calculated from the operating
current consumption without load.
Average operating current can be obtained by the equation:
I
= C ･V ･f + I /6 (per gate)
PD CC IN CC
CC (opr)
4
2007-10-01
TC74AC05P/F/FN
Package Dimensions
Weight: 0.96 g (typ.)
5
2007-10-01
TC74AC05P/F/FN
Package Dimensions
Weight: 0.18 g (typ.)
6
2007-10-01
TC74AC05P/F/FN
Package Dimensions (Note)
Note: This package is not available in Japan.
Weight: 0.12 g (typ.)
7
2007-10-01
TC74AC05P/F/FN
RESTRICTIONS ON PRODUCT USE
20070701-EN GENERAL
• The information contained herein is subject to change without notice.
• TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor
devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical
stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of
safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of
such TOSHIBA products could cause loss of human life, bodily injury or damage to property.
In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as
set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and
conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability
Handbook” etc.
• The TOSHIBA products listed in this document are intended for usage in general electronics applications
(computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances,
etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires
extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or
bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or
spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments,
medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his
document shall be made at the customer’s own risk.
• The products described in this document shall not be used or embedded to any downstream products of which
manufacture, use and/or sale are prohibited under any applicable laws and regulations.
• The information contained herein is presented only as a guide for the applications of our products. No
responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which
may result from its use. No license is granted by implication or otherwise under any patents or other rights of
TOSHIBA or the third parties.
• Please contact your sales representative for product-by-product details in this document regarding RoHS
compatibility. Please use these products in this document in compliance with all applicable laws and regulations
that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses
occurring as a result of noncompliance with applicable laws and regulations.
8
2007-10-01
相关型号：
TC74AC05F(TP1)
IC AC SERIES, HEX 1-INPUT INVERT GATE, PDSO14, 0.300 INCH, PLASTIC, SOIC-14, Gate
TOSHIBA
TC74AC05F(TP2)
IC AC SERIES, HEX 1-INPUT INVERT GATE, PDSO14, 0.300 INCH, PLASTIC, SOIC-14, Gate
TOSHIBA
TC74AC05FN-ELP
IC AC SERIES, HEX 1-INPUT INVERT GATE, PDSO14, 0.150 INCH, PLASTIC, SOIC-14, Gate
TOSHIBA
©2020 ICPDF网 联系我们和版权申明