2SK3127_09 [TOSHIBA]

Chopper Regulator, DC-DC Converter and Motor Drive Applications; 斩波稳压器， DC-DC转换器和电机驱动应用


型号：	2SK3127_09
厂家：	TOSHIBA
描述：	Chopper Regulator, DC-DC Converter and Motor Drive Applications 斩波稳压器， DC-DC转换器和电机驱动应用转换器稳压器电机驱动 DC-DC转换器
文件：	总3页 (文件大小：133K)
中文：	中文翻译
下载：	下载PDF数据表文档文件

2SK3127

TOSHIBA Field Effect Transistor Silicon N Channel MOS Type (π-MOS VI)

2SK3127

Chopper Regulator, DC-DC Converter and Motor Drive

Applications

Unit: mm

•

Low drain-source ON resistance: R

= 9.5 mΩ (typ.)

DS (ON)

High forward transfer admittance: |Y | = 38 S (typ.)

Low leakage current: I

= 100 μA (max) (V

= 30 V)

DSS

Enhancement-mode: V = 1.5 to 3.0 V (V

= 10 V, I = 1 mA)

Absolute Maximum Ratings (Ta = 25°C)

Characteristics

Drain-source voltage

Symbol

Rating

Unit

DSS

Drain-gate voltage (R

Gate-source voltage

= 20 kΩ)

DGR

±20

GSS

DC (Note 1)

Drain current

Pulse (Note 1)

135

Drain power dissipation (Tc = 25°C)

JEDEC

⎯

Single pulse avalanche energy

524

(Note 2)

JEITA

Avalanche current

TOSHIBA

Weight: 1.5 g (typ.)

2-10S1B

Repetitive avalanche energy (Note 3)

Channel temperature

°C

150

Storage temperature range

stg

−55 to 150

Note 1: Please use devices on condition that the channel temperature is

below 150°C.

Note 2:

= 25 V, T = 25°C (initial), L = 186 μH, R = 25 Ω, I

= 45 A

Note 3: Repetitive rating: pulse width limited by maximum junction

temperature.

Note 4: Using continuously under heavy loads (e.g. the application of high

temperature/current/voltage and the significant change in temperature, etc.)

may cause this product to decrease in the reliability significantly even if the

operating conditions (i.e. operating temperature/current/voltage, etc.) are

within the absolute maximum ratings. Please design the appropriate

reliability upon reviewing the Toshiba Semiconductor Reliability Handbook

(“Handling Precautions”/“Derating Concept and Methods”) and individual

reliability data (i.e. reliability test report and estimated failure rate, etc).

This transistor is an electrostatic sensitive device.

Please handle with caution.

JEDEC

⎯

Thermal Characteristics

JEITA

Characteristics

Symbol

Max

Unit

TOSHIBA

Weight: 1.5 g (typ.)

2-10S2B

Thermal resistance, channel to case

Thermal resistance, channel to ambient

1.92

83.3

°C/W

th (ch-c)

th (ch-a)

2009-09-29

2SK3127

Electrical Characteristics (Ta = 25°C)

Characteristics

Gate leakage current

Symbol

Test Condition

Min

Typ.

Max

Unit

= ±16 V, V = 0 V

⎯

1.5

⎯

±10

100

⎯

μA

GSS

Drain cut-off current

= 30 V, V

= 0 V

DSS

(BR) DSS

Drain-source breakdown voltage

Gate threshold voltage

Drain-source ON resistance

Forward transfer admittance

Input capacitance

= 10 mA, V

⎯

= 10 V, I = 1 mA

⎯

3.0

⎯

= 10 V, I = 25 A

9.5

mΩ

DS (ON)

|Y |

= 10 V, I = 25 A

= 10 V, V

= 0 V, f = 1 MHz

2300

380

1100

⎯

iss

rss

oss

Reverse transfer capacitance

Output capacitance

⎯

= 25 A

Rise time

⎯

10 V

OUT

0 V

Turn-on time

Switching time

Fall time

∼

−

15 V

Turn-off time

200

off

Duty ≤ 1%, t = 10 μs

Total gate charge

∼

−

24 V, V

= 10 V, I = 45 A

(gate-source plus gate-drain)

∼

−

Gate-source charge

24 V, V

= 10 V, I = 45 A

⎯

∼

−

Gate-drain (“miller”) charge

= 10 V, I = 45 A

Source-Drain Ratings and Characteristics (Ta = 25°C)

Characteristics

Symbol

Test Condition

Min

Typ.

Max

Unit

Continuous drain reverse current

⎯

(Note 1)

Pulse drain reverse current (Note 1)

Forward voltage (diode)

⎯

135

DRP

= 45 A, V

= 0 V

−1.7

DSF

= 0 V,

dI /dt = 50 A/μs

Reverse recovery time

⎯

150

270

⎯

= 45 A, V

= 0 V,

dI /dt = 50 A/μs

Reverse recovery charge

Marking

Note 5: A line under a Lot No. identifies the indication of product

Labels.

Not underlined: [[Pb]]/INCLUDES > MCV

Underlined: [[G]]/RoHS COMPATIBLE or [[G]]/RoHS [[Pb]]

K3127

Product No. (or abbreviation code)

Lot No.

Please contact your TOSHIBA sales representative for details as to

environmental matters such as the RoHS compatibility of Product.

The RoHS is the Directive 2002/95/EC of the European Parliament

and of the Council of 27 January 2003 on the restriction of the use of

certain hazardous substances in electrical and electronic equipment.

Note 5

2009-09-29

2SK3127

RESTRICTIONS ON PRODUCT USE

•

Toshiba Corporation, and its subsidiaries and affiliates (collectively “TOSHIBA”), reserve the right to make changes to the information

in this document, and related hardware, software and systems (collectively “Product”) without notice.

This document and any information herein may not be reproduced without prior written permission from TOSHIBA. Even with

TOSHIBA’s written permission, reproduction is permissible only if reproduction is without alteration/omission.

Though TOSHIBA works continually to improve Product’s quality and reliability, Product can malfunction or fail. Customers are

responsible for complying with safety standards and for providing adequate designs and safeguards for their hardware, software and

systems which minimize risk and avoid situations in which a malfunction or failure of Product could cause loss of human life, bodily

injury or damage to property, including data loss or corruption. Before creating and producing designs and using, customers must also

refer to and comply with (a) the latest versions of all relevant TOSHIBA information, including without limitation, this document, the

specifications, the data sheets and application notes for Product and the precautions and conditions set forth in the “TOSHIBA

Semiconductor Reliability Handbook” and (b) the instructions for the application that Product will be used with or for. Customers are

solely responsible for all aspects of their own product design or applications, including but not limited to (a) determining the

appropriateness of the use of this Product in such design or applications; (b) evaluating and determining the applicability of any

information contained in this document, or in charts, diagrams, programs, algorithms, sample application circuits, or any other

referenced documents; and (c) validating all operating parameters for such designs and applications. TOSHIBA ASSUMES NO

LIABILITY FOR CUSTOMERS’ PRODUCT DESIGN OR APPLICATIONS.

•

Product is intended for use in general electronics applications (e.g., computers, personal equipment, office equipment, measuring

equipment, industrial robots and home electronics appliances) or for specific applications as expressly stated in this document.

Product is neither intended nor warranted for use in equipment or systems that require extraordinarily high levels of quality and/or

reliability and/or a malfunction or failure of which may cause loss of human life, bodily injury, serious property damage or serious public

impact (“Unintended Use”). Unintended Use includes, without limitation, equipment used in nuclear facilities, equipment used in the

aerospace industry, medical equipment, equipment used for automobiles, trains, ships and other transportation, traffic signaling

equipment, equipment used to control combustions or explosions, safety devices, elevators and escalators, devices related to electric

power, and equipment used in finance-related fields. Do not use Product for Unintended Use unless specifically permitted in this

document.

•

Do not disassemble, analyze, reverse-engineer, alter, modify, translate or copy Product, whether in whole or in part.

Product shall not be used for or incorporated into any products or systems whose manufacture, use, or sale is prohibited under any

applicable laws or regulations.

•

The information contained herein is presented only as guidance for Product use. No responsibility is assumed by TOSHIBA for any

infringement of patents or any other intellectual property rights of third parties that may result from the use of Product. No license to

any intellectual property right is granted by this document, whether express or implied, by estoppel or otherwise.

ABSENT A WRITTEN SIGNED AGREEMENT, EXCEPT AS PROVIDED IN THE RELEVANT TERMS AND CONDITIONS OF SALE

FOR PRODUCT, AND TO THE MAXIMUM EXTENT ALLOWABLE BY LAW, TOSHIBA (1) ASSUMES NO LIABILITY

WHATSOEVER, INCLUDING WITHOUT LIMITATION, INDIRECT, CONSEQUENTIAL, SPECIAL, OR INCIDENTAL DAMAGES OR

LOSS, INCLUDING WITHOUT LIMITATION, LOSS OF PROFITS, LOSS OF OPPORTUNITIES, BUSINESS INTERRUPTION AND

LOSS OF DATA, AND (2) DISCLAIMS ANY AND ALL EXPRESS OR IMPLIED WARRANTIES AND CONDITIONS RELATED TO

SALE, USE OF PRODUCT, OR INFORMATION, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY, FITNESS

FOR A PARTICULAR PURPOSE, ACCURACY OF INFORMATION, OR NONINFRINGEMENT.

• Do not use or otherwise make available Product or related software or technology for any military purposes, including without limitation,

for the design, development, use, stockpiling or manufacturing of nuclear, chemical, or biological weapons or missile technology

products (mass destruction weapons). Product and related software and technology may be controlled under the Japanese Foreign

Exchange and Foreign Trade Law and the U.S. Export Administration Regulations. Export and re-export of Product or related software

or technology are strictly prohibited except in compliance with all applicable export laws and regulations.

•

Please contact your TOSHIBA sales representative for details as to environmental matters such as the RoHS compatibility of Product.

Please use Product in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances,

including without limitation, the EU RoHS Directive. TOSHIBA assumes no liability for damages or losses occurring as a result of

noncompliance with applicable laws and regulations.

2009-09-29

2SK3127_09 [TOSHIBA]

相关型号：

2SK3128

2SK3128_06

2SK3128_09

2SK3129

2SK3129_06

2SK313

2SK3130

2SK3130

2SK3130_06

2SK3130_09

2SK3131

2SK3131(Q)