BA3812F [ROHM]
Equalizer Circuit, 1 Channel(s), PDSO18, SOP-18;
| 型号： | BA3812F |
| 厂家： | 
ROHM |
| 描述： | Equalizer Circuit, 1 Channel(s), PDSO18, SOP-18 |
| 文件： | 总6页 (文件大小：92K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
Audio ICs
5-channel graphic equalizer
BA3812L
The BA3812L is a five-point graphic equalizer that has all the required functions integrated onto one IC. The IC is com-
prised of the five tone control circuits and input and output buffer amplifiers.
The BA3812L features low distortion, low noise, and wide dynamic range, and is an ideal choice for Hi-Fi stereo applica-
tions. It also has a wide operating voltage range (3.5V to 16V), which means that it can be adapted for use with most
types of stereo equipment.
The five center frequencies are independently set using external capacitors, and as the output stage buffer amplifier and
tone control section are independent circuits, fine control over a part of the frequency bandwidth is possible, By using
two BA3812Ls, it is possible to construct a 10-point graphic equalizer.
The amount of boost and cut can be set by external components.
FApplications
Radio cassette players, home stereo systems and car stereo systems.
FFeatures
1) Minimizes the number of components required to
build a graphic equalizer.
4) Low current dissipation (5 mA).
5) Wide dynamic range (VOM = 2.1Vrms /VCC = 8V).
6) Built-in input and output buffer amplifiers.
2) Low distortion and low noise.
3) Wide operating power supply voltage range (3.5V to
16V).
FAbsolute maximum ratings (Ta = 25_C)
FRecommended operating conditions (Ta = 25_C)
445
Audio ICs
BA3812L
FBlock diagram
FElectrical characteristics (unless otherwise noted, Ta = 25_C, VCC = 8V, and fin = 1kHz)
446
Audio ICs
BA3812L
FMeasurement circuit
FApplication example
447
Audio ICs
BA3812L
By using more than one IC the following applications are
also possible:
(2) 7-point stereo graphic equalizer
As shown in Fig. 3, with three ICs it is possible to
construct a 7-point stereo graphic equalizer. Two
BA3812L ICs are used to construct a 5-point stereo
graphic equalizer, and two of the active inductor circuits
from a third BA3812L are added to each.
(1) 10-point single-channel graphic equalizer
As shown in Fig. 2, with two ICs it is possible to construct
a 10-point single-channel graphic equalizer,
448
Audio ICs
BA3812L
FSolid-state inductor
The resonance frequency is obtained from the following
formula:
A solid state inductor uses an active element and has the
equivalent function of an inductor. The circuit shown in
Fig. 4 is used in the BA3812L. This circuit employs two
capacitors, a potentiometer, and a bias capacitor as ex-
ternal components, everything else is on the chip.
The resonance frequency (fo) and the Q of the circuit are
fixed by the values of the external capacitors.
1
fo (Hz) =
(R: Ω, C: F)
2π R0R1CC0
Q is the factor that determines the bandwidth of the fre-
quency. If the amount of boost and cut are the same for
the same resonance frequency, the larger the value of Q,
the narrower the resonant frequency band.
The circuit Q is obtained from the following formula:
CR1
Q =
CO RO
FElectrical characteristic curves
449
Audio ICs
BA3812L
FExternal dimensions (Units: mm)
450
相关型号：
©2020 ICPDF网 联系我们和版权申明