ET-5MS-OEM [REDLION]
OEM Industrial Ethernet Managed Switchsolutions;
| 型号： | ET-5MS-OEM |
| 厂家： | 
Red Lion Controls. Inc |
| 描述： | OEM Industrial Ethernet Managed Switchsolutions |
| 文件： | 总2页 (文件大小：1824K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
ET-5MS-OEM Industrial Ethernet Switch
Sixnet Networking Series
OEM Industrial Ethernet Managed Switch
TheET-5MS-OEMisa6portindustrialEthernetswitchdesigned
for OEM embedded applications. It allows you to easily and
quickly create your own custom switch or Ethernet enable your
existing OEM system. This powerful off-the-shelf solution will
save you time and money!
PRODUCT HIGHLIGHTS
n
Board level design for embedded applications
n
6 ports for flexible interfacing including one MII
n
Complete Ethernet PHY and magnetics on-board
n
Extra output lines to drive external LEDs
n
Low power consumption – less than 2 Watts
Create your own unique products as shown
REAL-TIME ETHERNET PERFORMANCE
n
Fast wire-speed switching
n
Intelligent message routing - No collisions!
n
Real-time Ring® and Rapid Spanning Tree (RSTP) for
fast redundant ring or mesh connections
n
SNMPv1 and v2 network management
n
SNMPv3 authentication & encryption for security
n
SNMP notifications (traps) for report on event
n
Priority Queuing (QoS/CoS) for real-time operation
n
IGMP for Multicast filtering (snooping & querying)
n
VLAN for convenient traffic segregation
n
Broadcast & multicast storm protection
n
Ideal for commercial
off the shelf solutions
RMON & port mirroring for advanced diagnostics
n
Security with HTTPS, SSL, SSH, SNMPv3 & more
n
Easy to use interfaces: web, CLI or Telnet
n
Sixnet Knows Industrial
ꢀ Free firmware upgrades forever
We have been designing industrial hardware such as
Remote Terminal Units for over 30 years and have used
this expertise to design the toughest Ethernet switches
on the market. Don’t trust your critical communications
to so-called industrial hardware from commercial switch
manufacturers. Sixnet switches give you proven assurance
that your system will keep running for years to come.
INDUSTRIAL TOUGH – READY FOR ANY APPLICATION
n
Ultra-reliable 1,000,000+ hours MTBF
n
UL/CSA (CUL), CE and hazloc (Zone 2) rated
n
-40 to 75°C operating range
n
Self-test/alarm output signal
ET-5MS-OEM Industrial Ethernet Switch Specifications
ETHERNET PERFORMANCE
ETHERNET COMPLIANCE
n
n
n
n
n
n
n
n
n
Fully managed with 6 Ethernet ports
IEEE 802.3 (10Mbps Ethernet supports legacy devices)
n
n
n
Store & forward wire-speed switching
Automatic address learning, aging and migration
Full duplex operation with flow control (no collisions)
All IEEE 802.3 Ethernet protocols supported
MAC addresses supported 2048
IEEE 802.3u (Fast Ethernet 100Mbps for newer devices)
IEEE 802.3x (Full-Duplex with Flow Control)
IEEE 802.1D/w, 802.1p, 802.1Q and much more
POWER INPUT
n
Power input voltage: 3.3 VDC (regulated)
n
Memory bandwidth 3.2 Gbps
Input power (typical - all ports active at 100 Mbps)
pꢀ
Typical latency (varies on load and settings)
<1.65 W (<500 mA @ 3.3 VDC)
pꢀ
@ 100 Mbps: 5 µs + frame time
ENVIRONMENTAL
pꢀ
n
@ 10 Mbps: 16 µs + frame time
Operating temperature: -40 to +75°C (cold startup at -40)
n
n
n
n
Ethernet isolation 1500 VRMS 1 minute
Storage temperature: -40 to +85 °C
Humidity (non-condensing) 5 to 95% RH
Vibration and shock: IEC60068-2-6
ETHERNET PORTS
n
6 fast (10/100) Ethernet ports total
n
n
n
4 with on-board PHYs and magnetics; these are available
through board-to-board or ribbon connector
STANDARDS COMPLIANCE
n
Electrical safety - UL508/CSA C22.2/14, EN61010-1, CE
1 with on board PHY (by requires external magnetics);
available through board-to-board connector
n
n
EMC - FCC part 15, ICES-003; EN61000-6, CE
Hazardous locations: UL1604/CSA C22.2/213 (Class I, Div.
2); EN60079-15 (Zone 2, Category 3), CE (ATEX)
1 is an MII port for interface to an external CPU or PHY
or fiber optic transceiver; available through board-to-board
connector
ORDERING GUIDE
n
Ports support plug and play operation
et-5ms-oem-2-1
OEM switch with Molex connectors
pꢀ
Auto-negotiation for 10 or 100 Mbps
et-5ms-oem-2-1B
OEM switch with Samtec connectors plus
Molex ribbon
pꢀ
Auto-MDI/MDIX-crossover for either cable type
pꢀ
Auto-polarity corrects for crossed +/- signals
Reference mechanical diagram
MECHANICAL DRAWING
All specifications are subject to change. Consult factory for latest info.
As the global experts in communication, monitoring and control for
industrial automation and networking, Red Lion has been delivering
innovative solutions for over forty years. Our award-winning
technology enables companies worldwide to gain real-time data
visibility that drives productivity. Product brands include Red Lion,
N-Tron and Sixnet. With headquarters in York, Pennsylvania, the
company has offices across the Americas, Asia-Pacific and Europe.
For more information, please visit www.redlion.net. Red Lion is a
Spectris company.
Americas
sales@redlion.net
Asia-Pacific
asia@redlion.net
Europe
Middle East
Africa
w w w . r e d l i o n . n e t
europe@redlion.net
Connect. Monitor. Control.
ADLD0169 082213 ©2013 Red Lion Controls
+1 (717) 767-6511
相关型号：
©2020 ICPDF网 联系我们和版权申明