PLL602-00DI [PLL]
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals; 乘数XO IC晶片12〜 25MHz的并联谐振晶体
| 型号： | PLL602-00DI |
| 厂家： | 
PHASELINK CORPORATION |
| 描述： | Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals |
| 文件： | 总4页 (文件大小：174K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
PLL602-00
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals
FEATURES
DIE CONFIGURATION
65 mil
•
•
Integrated crystal oscillator circuitry (XO).
Low phase noise (-135dBc @ 10kHz offset)
selectable frequency multipliers (x1, x2, x4, x8
as bonding options).
(1550,1475)
25
23
21
20
19
18
Die ID:
A0303-03H
•
•
3.3V supply voltage.
27
29
XIN
Uses inexpensive fundamental-mode parallel
resonant crystals (from 12 to 25MHz).
Selectable High Drive (30mA) or Standard Drive
(10mA) output.
•
•
13
10
CLK
XOUT
Available in DIE (65 mil x 62 mil).
GND
C502A
DESCRIPTION
7
The PLL602-00 is a monolithic low jitter and low
phase noise (-135dBc @10kHz offset), high
performance CMOS XO IC. This flexible device can
be used as a XO with output frequencies ranging
from FXIN x 1 to FXIN x 8 thanks to selector pads
allowing bonding options (see Divider Selection
Table on this page). This makes the PLL602-00 ideal
for a wide range of applications from 12MHz to
200MHz (including 50MHz, 77.76MHz, 125MHz and
155.52MHz, etc.).
(0,0)
Y
Note: ^ denotes internal pull up
V denotes internal pull down
X
MULTIPLIER SELECTION
SELECTION
FXIN
CLK (MHz)
S2
0
S1
0
S0
0
FXIN x 2
FXIN x 4
FXIN x 1
FXIN x 8
FXIN x 2*
FXIN x 4*
FXIN x 1*
FXIN x 8*
0
0
1
0
1
1
1
0
1
0
1
1
0
1
1
0
0
1
0
1
1
12MHz – 25MHz
BLOCK DIAGRAM
S[0:2]
XIn
Selectable
Note: - Selector pads default to ‘0’, wire bond to VDD to set to ‘1’
XO
CLK
PLL
- (*) High-drive CMOS output
XOut
PAD DESCRIPTION
Name
Number
Description
XIN
XOUT
GND
CLK
27
29
Crystal input connection.
Crystal connection.
Ground.
DIE SPECIFICATIONS
7,10
13
Name
Value
Clock Output.
Size
62 x 65 mil
GND
S[0:2]
VDD
18,19,20 Frequency selection pad
21,22,23 3.3V Power Supply.
Reverse side
Pad dimensions
Thickness
80 micron x 80 micron
10 mil
Output Enable: ‘0’ to disable (tri-
state output), 1’ (default value
when not connected) to enabled
the output.
OE
25
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 1
PLL602-00
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings
PARAMETERS
SYMBOL
MIN.
MAX.
UNITS
Supply Voltage
VDD
VI
4.6
VDD+0.5
VDD+0.5
150
V
Input Voltage, dc
-0.5
-0.5
-65
V
Output Voltage, dc
VO
TS
TA
TJ
V
Storage Temperature
°C
°C
°C
°C
kV
Ambient Operating Temperature*
Junction Temperature
-40
85
125
Lead Temperature (soldering, 10s)
ESD Protection, Human Body Model
260
2
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the
device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other
conditions above the operational limits noted in this specification is not implied.
* Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only.
2. DC Electrical Specifications
PARAMETERS
SYMBOL
CONDITIONS
MIN.
TYP.
MAX.
UNITS
Supply Current, Dynamic, with
Loaded Outputs
FXIN = 12 - 25MHz
Output load of 10pF
IDD
16
20
mA
Operating Voltage
VDD
IOH
IOL
2.97
30
3.63
V
VOH= VDD-0.4V, VDD=3.3V
VOL = 0.4V, VDD = 3.3V
VOH= VDD-0.4V, VDD=3.3V
VOL = 0.4V, VDD = 3.3V
mA
mA
mA
mA
mA
Output drive current
(High Drive)
30
IOH
IOL
10
Output drive current
(Standard Drive)
10
Short Circuit Current
±50
3. AC Electrical Specifications
PARAMETERS
SYMBOL
CONDITIONS
MIN.
TYP.
MAX.
UNITS
Input Crystal Frequency
12
25
MHz
Output Clock Rise/Fall Time
(Standard Drive)
Output Clock Rise/Fall Time
(High Drive)
0.3V ~ 3.0V with 15 pF load
2.4
ns
%
0.3V ~ 3.0V with 15 pF load
Measured @ 50% VDD
1.2
50
Output Clock Duty Cycle
45
55
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 2
PLL602-00
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals
4. Crystal Specifications
PARAMETERS
SYMBOL
CONDITIONS
MIN.
TYP.
MAX.
UNITS
Crystal Resonator Frequency
Crystal Loading Rating
Recommended ESR
FXIN
CL (xtal)
RE
Parallel Fundamental Mode
12
25
MHz
pF
20
AT cut
30
Ω
5. Jitter and Phase Noise Specification
PARAMETERS CONDITIONS
MIN.
TYP.
MAX.
UNITS
at 155MHz, with capacitive decoupling
between VDD and GND.
4
3
RMS Period Jitter
at 80MHz, with capacitive decoupling
between VDD and GND.
ps
(1 sigma – 1000 samples)
at 44MHz, with capacitive decoupling
between VDD and GND.
2.5
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
Phase Noise relative to carrier
44MHz @100Hz offset
44MHz @1kHz offset
44MHz @10kHz offset
44MHz @100kHz offset
44MHz @1MHz offset
155MHz @100Hz offset
155MHz @1kHz offset
155MHz @10kHz offset
155MHz @100kHz offset
155MHz @1MHz offset
-80
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
-110
-135
-130
-132
-80
-110
-125
-120
-125
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 3
PLL602-00
Multiplier XO IC Die for 12 to 25MHz Parallel Resonant Crystals
PAD ASSIGNMENT
Pad #
Name
Description
X (µm)
Y (µm)
7
GND
GND
CLK
1042
1400
1400
109
259
716
Ground.
10
13
Ground.
CMOS clock output.
Used to select multiplication factor and drive level. Internal pull
down.
18
19
20
S2
S1
S0
1232
1042
854
1365
1365
1365
Used to select multiplication factor and drive level. Internal pull
down.
Used to select multiplication factor and drive level. Internal pull
down.
21
23
25
27
29
VDD
VDD
OE
659
459
194
109
109
1365
1365
1365
1017
646
3.3V power supply.
3.3V power supply.
Used to enable/disable the output(s). Internal pull up.
Crystal input. See crystal specification page 3.
Crystal output. See crystal specification page 3.
XIN
XOUT
ORDERING INFORMATION
For part ordering, please contact our Sales Department:
47745 Fremont Blvd., Fremont, CA 94538, USA
Tel: (510) 492-0990 Fax: (510) 492-0991
PART NUMBER
The order number for this device is a combination of the following:
Device number, Package type and Operating temperature range
PLL602-00 D C
TEMPERATURE
C=COMMERCIAL
I=INDUSTRAL
PART NUMBER
PACKAGE TYPE
D=DIE
Order Number
PLL602-00DC
Marking
Package Option
Die – Waffle Pack
P602-00DC
PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information
furnished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said
information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.
LIFE SUPPORT POLICY: PhaseLink’s products are not authorized for use as critical components in life support devices or systems
without the express written approval of the President of PhaseLink Corporation.
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/03/04 Page 4
相关型号：
©2020 ICPDF网 联系我们和版权申明