WR11BFN [NKK]
Environmentally Sealed Rockers; 环境密封摇椅
| 型号： | WR11BFN |
| 厂家： | 
NIHON KAIHEIKI INDUSTRY CO. LTD. |
| 描述： | Environmentally Sealed Rockers |
| 文件： | 总5页 (文件大小：210K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
Environmentally Sealed Rockers Series WR
Distinctive Characteristics
Single unit construction of the flange and outer housing
gives added protection from environmental elements.
Specially designed contact mechanism
for breaking light welds.
Minimal contact bounce achieved with
specially designed interlocked switching
mechanism.
Heat resistant resin used for outer housing, inner
case, and cover on wire lead models meets
UL94V-0 flammability standard and provides
high arc and tracking resistance.
Addition of new .250” quick connect terminal option.
Now available with solder lug, screw, quick connect,
and wire lead terminations.
Sealed Construction Meets IP60 & IP67 Standards
Actual Size
Solder lug, screw, and quick connect terminal models
meet IP67 of IEC60529 Standards at front panel (dust
tight and water protected for temporary immersion,
patent pending). Behind panel standard is IP60 (dust
tight but not water protected).
Wire lead models conform fully to IP67 of IEC60529
Standards at front and behind panel (dust tight and
water protected for temporary immersion). Switch
base is epoxy sealed and covered by an outer case
for further protection from dust and water. (Switches
cannot be operated under water. Contact factory for
further details regarding operating environment.)
NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com
05-07
Environmentally Sealed Rockers Series WR
General Specifications
Electrical Capacity (Resistive Load)
Power Level:
15A @ 125/250V AC or 15A @ 30V DC
Other Ratings
Contact Resistance:
10 milliohms maximum for solder lug, screw & quick connect terminal models
30 milliohms maximum for wire lead terminal models
200 megohms minimum @ 500V DC
1,250V AC minimum between contacts for 1 minute minimum
3,750V AC minimum between contacts & case for 1 minute minimum
30,000 operations minimum
15,000 operations minimum for circuit 11 and 12 models
10,000 operations minimum for circuit 13, 15, 18, 19 models
24°
Insulation Resistance:
Dielectric Strength:
Mechanical Life:
Electrical Life:
Angle of Throw:
Materials & Finishes
Rocker:
Phenylene oxide
Polyamide (UL94V-0)
Melamine (UL94V-0)
Outer Housing:
Inner Case:
Cover for Wire Lead Models:
Flange Gasket:
Glass fiber reinforced polyamide (UL94V-0)
Nitrile butadiene rubber
Copper with silver plating
Silver alloy plus copper with silver plating
Silver alloy plus copper with silver plating
Copper with tin plating for solder lug & wire lead
Brass with silver plating for screw lug
Brass with tin plating for quick connect
Heat resistant polyvinyl chloride (Leads are AWG 14)
Movable Contactor:
Movable Contacts:
Stationary Contacts:
Terminals:
Wire Lead Covers:
Environmental Data
Operating Temp Range:
Humidity:
–25°C through +85°C (–13°F through +185°F)
90 ~ 95% humidity for 96 hours @ 40°C (104°F)
Vibration:
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 1 minute; 3 right angled directions for 2 hours
Shock:
Front Panel Seal:
Behind Panel Seal:
50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction)
IP67 of IEC60529, dust tight & water protected during temporary immersion for all models
IP60 of IEC60529, dust tight but not water protected for solder lug, screw & quick connect models
IP67 of IEC60529, dust tight & water protected during temporary immersion for wire lead models
Installation
Soldering Time & Temp:
Cleaning:
Manual Soldering: See Profile A in Supplement section.
Hand clean locally using alcohol based solution.
Standards & Certifications
Flammability Standards:
UL94V-0 outer housing, inner case, & outer cover on wire lead models
Solder & screw lug models recognized at 15A @ 125/250V AC & 15A @ 30V DC;
UL File No. WOYR2.E44145. Add “/U” to end of part number to order UL mark on switch.
Solder & screw lug models recognized at 15A @ 125/250V AC & 15A @ 30V DC;
C-UL File No. WOYR8.E44145. Add “/C-UL” to end of part number to order C-UL mark on switch.
All models approved at 15A @ 250V AC (pending for quick connect); VDE License No. 126501.
Add “/V” to end of part number to order VDE mark on switch.
UL Recognized:
R
C-UL Recognized:
R
VDE Approved:
V
D
E
EN Conformity:
Wiring Material Standards:
WR11 & WR12 models meet European Norm for 3mm contact gap to prevent contact welds;
EN No. 61058-1
UL AWM 1015 Recognized at Flammability VW-1;
Temperature Range –20°C ~ +105°C; Maximum Load 600V; AWG 14.
CSA TEW 105 Certified at Temperature Range –20°C ~ +105°C; Maximum Load 600V
NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com
05-07
Environmentally Sealed Rockers Series WR
TYPICAL SWITCH ORDERING EXAMPLE
WR
1
2
B
S
POLES
TERMINALS
SPST
SPDT
Solder Lug with
Epoxy Seal
1
S
CIRCUITS
ROCKERS
Black
Solder Lug without
Epoxy Seal
SN
T
1
2
3
5
8
9
ON NONE OFF
ON NONE ON
A
* B
Ivory
Screw Lug with
Epoxy Seal
Contact Factory
for Quick Connect
with Ivory Rocker
*
ON
OFF
ON
ON NONE (ON)
Screw Lug without
Epoxy Seal
TN
(ON)
ON
OFF
OFF
(ON)
(ON)
.250” (6.35mm)
Quick Connect
with Epoxy Seal
F
(
) = Momentary
.250” (6.35mm)
Quick Connect
without Epoxy Seal
FN
L
Wire Lead
IMPORTANT:
Switches are supplied without UL,
C-UL, & VDE marking unless specified.
Specific models & ratings noted on
General Specifications page.
DESCRIPTION FOR TYPICAL ORDERING EXAMPLE
WR12BS
Ivory Rocker
SPDT
ON-NONE-ON Circuit
Solder Lug Terminals with Epoxy Seal
NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com
05-07
Environmentally Sealed Rockers Series WR
POLES & CIRCUITS
Rocker Position
Connected Terminals
Throw & Schematics
(
) = Momentary
Down
Center
Up
Down
Center
Up
Note: Terminal numbers are not
actually on wire lead models.
Pole
Model
WR11
1a (COM)
SP
ON
NONE
OFF
1a-1b
1-1b
OPEN
OPEN
OPEN
1-1a
SPST
1b
WR12
WR13
WR15
WR18
WR19
ON
ON
ON
(ON)
ON
NONE
OFF
NONE
OFF
ON
ON
(ON)
(ON)
(ON)
1 (COM)
SP
SPDT
1a
1b
OFF
TYPICAL SWITCH DIMENSIONS
Solder Lug Terminals
(7.8)
.307
(2.4) Dia Typ
.094
(4.8) Typ
.189
NKK P/N This Side
1a
(11.3) Typ
.445
(41.0)
1.614
(28.8)
1.134
(34.2)
1.346
24°
1
(30.0)
1.181
(25.4)
1.00
(34.2)
1.346
1b
(17.2)
.677
(15.8)
.622
(4.8)
.189
(0.8) Typ
.031
(12.9)
.508
(17.2)
.677
(2.5)
.098
(35.4)
1.394
(24.0)
.945
Panel Thickness
.039” ~ .157”
(1.0mm ~ 4.0mm)
WR12AS
WR11 model does not have terminal 1.
Screw Lug Terminals
(7.8)
.307
NKK P/N This Side
(6.6) Typ
.260
M3.5 x 5 Typ
1a
(11.2) Typ
.441
(41.0)
1.614
1
(28.8)
1.134
(34.2)
1.346
24°
(30.0)
1.181
(25.4)
1.00
(34.2)
1.346
1b
(17.2)
.677
(15.8)
.622
(8.3)
.327
(1.0) Typ
.039
(12.9)
.508
(17.2)
.677
(24.0)
.945
(2.5)
.098
(38.9)
1.531
Panel Thickness
.039” ~ .157”
(1.0mm ~ 4.0mm)
WR12AT
WR11 model does not have terminal 1.
NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com
05-07
Environmentally Sealed Rockers Series WR
TYPICAL SWITCH DIMENSIONS
.250” (6.35mm) Quick Connect Terminals
(1.65)DiaTyp
.065
(0.8)Typ
.031
(7.8)
.307
NKK P/N This Side
1a
(22.6)
.890
1
(28.8)
1.134
(6.35) (7.5)
.250 .295
(34.2)
1.346
24˚
(41.0)
1.614
(25.4)
1.00
1b
(30.0)
1.181
(34.2)
1.346
(3.6)
.142
(3.95)
.156
(17.2)
.677
(7.95)
.313
(10.75)
.423
(15.8)
.622
(17.2)
.677
(12.9)
.508
(24.0)
(2.5)
.098
(41.35)
1.628
Panel Thickness
.039” ~ .157”
(1.0mm ~ 4.0mm)
WR13AF
WR11 model does not have terminal 1.
Wire Lead Terminals
NKK P/N This Side
(7.8)
.307
1a
(41.0)
1.614
(34.2)
1.346
(34.2)
1.346
24°
1
(30.0)
1.181
(25.4)
1.00
1b
(17.2)
.677
(10.0)
.394
(12.9)
.508
+
(20.0)
(24.0)
.945
(2.5)
.098
(39.5)
1.555
(200.0)
7.874
–
(17.2)
.677
Panel Thickness
.039” ~ .157”
(1.0mm ~ 4.0mm)
WR15BL
WR11 model does not have terminal 1.
STANDARD WIRE COLOR SCHEME
Terminal Numbers & Wire Colors
Wire leads are covered with heat
resistant vinyl in accordance with
UL 1015 and CSA TEW 105
Standards for Appliance Wiring
Material (AWM).
1a
1
1b
WR11
Black
White
White
Red
WR12-19
Black
NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com
05-07
相关型号：
©2020 ICPDF网 联系我们和版权申明