M2DNY-243P/UL 概述
Super-mini Signal Conditioners Mini-M Series
M2DNY-243P/UL 数据手册
通过下载M2DNY-243P/UL数据手册来全面了解它。这个PDF文档包含了所有必要的细节,如产品概述、功能特性、引脚定义、引脚排列图等信息。
PDF下载MODEL: M2DNY
Z: Specify current (See OUTPUT SPECIFICATIONS)
Super-mini Signal Conditioners Mini-M Series
Voltage
1: 0 – 10 mV DC (Load resistance 10 kΩ min.)
2: 0 – 100 mV DC (Load resistance 100 kΩ min.)
3: 0 – 1 V DC (Load resistance 1000 Ω min.)
4: 0 – 10 V DC (Load resistance 10 kΩ min.)
5: 0 – 5 V DC (Load resistance 5000 Ω min.)
6: 1 – 5 V DC (Load resistance 5000 Ω min.)
0: Specify voltage (See OUTPUT SPECIFICATIONS)
CURRENT LOOP SUPPLY
(with square root extraction, square root extractor)
Functions & Features
• Powers a 4 – 20 mA DC current loop
• Square root extraction
• Shortcircuit protection
• Applicable to smart transmitters
[2] POWER INPUT
Typical Applications
AC Power
• Various 2-wire transmitters
M: 85 – 264 V AC (Operational voltage range 85 – 264 V,
47 – 66 Hz)
23 (.91)
(Select ‘/N’ for ‘Standards & Approvals’ code.)
M2: 100 – 240 V AC (Operational voltage range 85 – 264 V,
47 – 66 Hz)
Model
76
(2.99)
(90 – 264 V for UL)
DC Power
ZERO
R: 24 V DC
SPAN
124
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
R2: 11 – 27 V DC
(4.88)
mm (inch)
(Operational voltage range 11 – 27 V, ripple 10 %p-p max.)
(Select ‘/N’ for ‘Standards & Approvals’ code.)
P: 110 V DC
MODEL: M2DNY–24[1]–[2][3]
(Operational voltage range 85 – 150 V, ripple 10 %p-p max.)
(110 V ±10 % for UL)
ORDERING INFORMATION
• Code number: M2DNY-24[1]-[2][3]
Specify a code from below for each [1] through [3].
(e.g. M2DNY-24A-M2/CE/Q)
[3] OPTIONS (multiple selections)
Standards & Approvals (must be specified)
/N: Without CE or UL
• Special output range (For codes Z & 0)
• Specify the specification for option code /Q
(e.g. /C01/S01)
/CE: CE marking
/UL: UL approval, CE marking
Other Options
blank: none
SUPPLY OUTPUT
/Q: Option other than the above (specify the specification)
24: 24 V DC
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
INPUT
Current
4 – 20 mA DC
/C02: Polyurethane coating
/C03: Rubber coating (UL not available)
TERMINAL SCREW MATERIAL
[1] OUTPUT
Current
/S01: Stainless steel (UL not available)
A: 4 – 20 mA DC (Load resistance 750 Ω max.)
B: 2 – 10 mA DC (Load resistance 1500 Ω max.)
C: 1 – 5 mA DC (Load resistance 3000 Ω max.)
D: 0 – 20 mA DC (Load resistance 750 Ω max.)
E: 0 – 16 mA DC (Load resistance 900 Ω max.)
F: 0 – 10 mA DC (Load resistance 1500 Ω max.)
G: 0 – 1 mA DC (Load resistance 15 kΩ max.)
M2DNY SPECIFICATIONS
ES-5066 Rev.8 Page 1/3
http://www.m-system.co.jp/
MODEL: M2DNY
GENERAL SPECIFICATIONS
Construction: Plug-in
INSTALLATION
Power Consumption
•AC:
Connection: M3 screw terminals (torque 0.8 N·m)
Screw terminal: Chromated steel (standard) or stainless
steel
Approx. 3 VA at 100 V
Approx. 4 VA at 200 V
Approx. 5 VA at 264 V
•DC: Approx. 3 W
Housing material: Flame-resistant resin (black)
Isolation: Input to output to power
Overrange output: 0 to 110 % at 1 – 5 V
Zero adjustment: -5 to +5 % (front)
Span adjustment: 95 to 105 % (front)
Low-end cutout: Approx. 4 – 8 % (output)
Operating temperature: -5 to +55°C (23 to 131°F)
Operating humidity: 30 to 90 %RH (non-condensing)
Mounting: Surface or DIN rail
Weight: 150 g (0.33 lb)
PERFORMANCE in percentage of span
Accuracy: ±0.2 % (input 1 – 100 %)
8% or less
Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)
Response time: ≤ 0.5 sec. (0 – 90 %)
Line voltage effect
4% or more
0
Supply output: ±3 % over voltage range
Output signal: ±0.1 % over voltage range
Insulation resistance: ≥ 100 MΩ with 500 V DC
Dielectric strength: 2000 V AC @1 minute (input to output
to power to ground)
INPUT
SUPPLY OUTPUT
(across the terminals 1 – 8)
Output voltage: 24 – 28 V DC with no load
18 V DC min. at 20 mA
STANDARDS & APPROVALS
EU conformity:
Current rating: ≤ 22 mA DC
• Shortcircuit Protection
EMC Directive
Current limited: 30 mA max.
Protected time duration: No limit
EMI EN 61000-6-4
EMS EN 61000-6-2
Low Voltage Directive
INPUT SPECIFICATIONS
EN 61010-1
■ DC Current: Input resistors incorporated
Approx. 300 Ω (50 Ω as receiving resistor, 250 Ω across the
monitor terminals)
Installation Category II
Pollution Degree 2
Input or output to power: Reinforced insulation (300 V)
Input to output: Basic insulation (300 V)
RoHS Directive
OUTPUT SPECIFICATIONS
■ DC Current: 0 – 20 mA DC
EN 50581
Approval:
Minimum span: 1 mA
UL/C-UL nonincendive Class I, Division 2,
Groups A, B, C, and D
Offset: Max. 1.5 times span
Load resistance: Output drive 15 V max.
■ DC Voltage: 0 – 12 V DC
(ANSI/ISA-12.12.01, CAN/CSA-C22.2 No.213)
UL/C-UL general safety requirements
(UL 61010-1, CAN/CSA-C22.2 No.61010-1)
Minimum span: 10 mV
Offset: Max. 1.5 times span
Load resistance: Output drive 1 mA max.; at ≥ 0.5 V
M2DNY SPECIFICATIONS
ES-5066 Rev.8 Page 2/3
http://www.m-system.co.jp/
MODEL: M2DNY
EXTERNAL DIMENSIONS & TERMINAL ASSIGNMENTS unit: mm (inch)
6 (.23)
DIN RAIL
35mm wide
4
1
5
8
2–4.2x5
(.17x.20)
MTG HOLE
6 (.24) deep
12
9
8–M3
SCREW
14 13
21.5 (.85) 10 (.39)
84 (3.31)
114 (4.49)
15 (.59)
[4 (.16)]
23 (.91)
• When mounting, no extra space is needed between units.
SCHEMATIC CIRCUITRY & CONNECTION DIAGRAM
Z
S
Isolation
Sq. Root
Extractor
Output
Driver
+
–
+
+
1
4
8
5
9
50Ω
INPUT
OUTPUT
POWER
–
12
13
14
2-WIRE XMTR
PWR SUPPLY
U(+)
V(–)
250Ω
–
Current
Limiter
V
MONITOR
1 – 5V DC
+
Base Socket
■ When Used as DC Supply
2-WIRE
TRANSMITTER
■ When Used as Square Root Extractor
+
–
+
+
–
–
1
4
8
5
1
4
8
5
50Ω
50Ω
INPUT
+
250Ω
250Ω
Specifications are subject to change without notice.
M2DNY SPECIFICATIONS
ES-5066 Rev.8 Page 3/3
http://www.m-system.co.jp/
M2DNY-243P/UL 相关器件
型号 | 制造商 | 描述 | 价格 | 文档 |
M2DNY-243R | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R/CE | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R/N | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R/Q | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R/UL | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R2 | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R2/CE | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R2/N | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R2/Q | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 | |
M2DNY-243R2/UL | MSYSTEM | Super-mini Signal Conditioners Mini-M Series | 获取价格 |
M2DNY-243P/UL 相关文章
- 2024-09-20
- 5
- 2024-09-20
- 8
- 2024-09-20
- 8
- 2024-09-20
- 6