EM800OAI25 [MRV]
LambdaDriver® - Optical Amplifi er Module;型号: | EM800OAI25 |
厂家: | MRV COMMUNICATIONS, INC. |
描述: | LambdaDriver® - Optical Amplifi er Module |
文件: | 总4页 (文件大小:1403K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
WDM & Optical Transport
Datasheet
LambdaDriver® - Optical Amplifier Module (EM800-OAx/EM1600-OAx)
Features
Booster, In line and Pre-Amplifier
Up to 22dBm maximum output power
Protocol and bandwidth transparent
Gain flatness (with GFF) less than 1.0 dB
Low Noise figure
Optical power monitoring
Front panel status LEDs
Fast transient suppression time
Automatic Laser Shutdown (ALS)
Mid-stage connection
Applications
DWDM networks
Single-channel amplification
Distance extention
Optical Amplifier modules
Optical Amplifier modules
Using MRV’s MegaVision WebNMS provides remote
family of low-noise Erbium-Doped Fiber Amplifiers control reducing the costly need for many infield service
(EDFA) ideal for Metro and Long-Haul Dense Wavelength
Division Multiplexing (DWDM) as well as Single
Wavelength applications. The optical design, coupled The modules allow monitoring of input and output
with sophisticated control circuitry, allows these power levels (real dBm values), temperature and signal
Optical Amplifiers to provide constant gain even with gain.
wavelengths being added or dropped in the network. The modules can be operated in two modes: automatic
Any fluctuations caused by wavelengths addition/ gain control or automatic power control.These operating
removal can be handled by its ultra-fast transient modes and their respective parameter settings are
suppression.
factory pre-configured but can be changed by MRV
authorized personnel.
When paired with the
Management Module ,full monitoring and configuration In AGC mode, the module maintains constant gain for
capabilities are supported with a local RS-232 interface each channel according to the Gain parameter setting,
as long as the total output power does not exceed the
network monitoring using Telnet and SNMP.
maximum rated value (+22 dBm). This mode is factory
pre-configured.
ꢌ�ꢡꢜꢜ
ꢌ�ꢡꢜꢜ
ꢌ�ꢞꢜꢜ
ꢟꢏꢐꢋꢠꢎꢑꢋ�ꢍꢏ
ꢟꢏꢐꢋꢠꢎꢑꢋ�ꢍꢏ
ꢟꢏꢐꢋꢠꢎꢑꢋ�ꢍꢏ
ꢟꢏꢐꢋꢠꢎꢑꢋ�ꢍꢏ
ꢙꢞꢛꢄꢗ
�ꢀ�ꢁ
ꢁꢂꢃ
ꢎꢏꢍ
ꢐꢁꢎ
�ꢀ�ꢁ
ꢁꢂꢃ
ꢟꢏꢐꢋꢠꢎꢑꢋ�ꢍꢏ
ꢟꢏꢐꢋꢠꢎꢑꢋ�ꢍꢏ
ꢄꢅꢅꢆꢇꢈꢉ
ꢊꢋ ꢌꢊꢋꢍ
ꢙꢚꢛꢄꢗ
ꢚꢜ ꢝꢗ
ꢡꢜ ꢝꢗ
ꢑꢒꢇꢓꢔꢕꢖ
ꢐꢗꢒꢖꢓꢘꢓꢈ
ꢉ
ꢑꢒꢇꢓꢔꢕꢖ
ꢐꢗꢒꢖꢓꢘꢓꢈ
ꢉ
Long Haul Application
ꢑꢒꢇꢓꢔꢕ
ꢖ ꢐꢗꢒꢖ
ꢓꢘꢓꢈꢉ
Not sure what solution best fits your needs? Visit www.mrv.com or e-mail us at sales@mrv.com
WDM & Optical Transport
In APC mode, the module maintains the output total Optical Amplifier modules provide Automatic Power
power constant at the pre-defined Output Power Shutdown, when input is below auto-shutdown
settings.
threshold. Power Shutdown can be also forced through
Additionaly each OA module with “M” in part number the management.
includes a special“Mid-stage”port for Optical Dispersion
Compensator.
The compact, 1-slot LambdaDriver Optical Amplifier
modules install into any of the LambdaDriver
There are 3 types of OAs: Booster, In-Line and Pre-
Amplifier. The main difference between these modules +18dBm total output power. Special“High Power”EDFA
is the Input power level that dictates the application of modules have maximum +22dBm total output power
the specific module and the Gain values. For example, that mainly serve high wavelength count (more than
Booster is usually used at the beginning of the line and 32 waves) DWDM or ultra long single span applications.
therefore Input levels above 0 dBm and Gain of 9 to15 These high power units are double slot size.
dB should be expected. On the other hand, Pre-Amplifier Each module provides visual indications of the front
Input level is very weak (down to –32 dBm/channel) panel and can be operated without management as
because it is positioned at the end of the line.
plug and play EDFA.
Multi-channel (DWDM) amplifiers are equipped with Besides DWDM networks application, LambdaDriver
Gain Flattening Filters (GFF) and provide flat gain EDFAs can be used in any Single channel application
response across entire C-band and input power range.
For single channel applications GFF cost is saved.
thus providing flexible means of extending an optical
link by compensating for optical budget loss.
Environment Specifications
Operating Temperature
Storage Temperature
Relative Humidity
ooC (23 ooF)
ooC (50 ooF)
85% maximum, non-condensing
Dimensions (W x H x D)
EM800 + 18dBm type
EM1600 + 18dBm type
EM800 High Power
EM1600 High Power
EM800 + 18dBm type
EM1600 + 18dBm type
EM800 High Power
26.93 mm (1.06 in) x 130.7 mm (5.145 in) x 227 mm (8.956 in) (1 slot wide)
26.93 mm (1.06 in) x 263.4 mm (10.37 in) x 227 mm (8.956 in) (1 slot wide)
54.18 mm (2.13 in) x 130.7 mm (5.14 in) x 227 mm (8.956 in) (2 slot wide)
54.18 mm (2.13 in) x 263.4 mm (10.37 in) x 227 mm (8.956 in) (2 slot wide)
0.586 Kg (1.28Lb)
Weight:
0.865 Kg (2.11Lb)
1.016 Kg (2.24Lb)
EM1600 High Power
1.305 Kg (2.47Lb)
Connectors
- High Power Ouput
WDM & Optical Transport
Technical Specifications
Parameter
Typical
Wavelength Range
Output power
With Mid-Stage
SOAB13, SOAI & Pre-Amplifier
High Power Booster
High Power In-line
Input power
25db gain In-Line
Pre-Amplifier
High Power Booster
High Power In-line
25db gain High Power In-Line
Signal Gain *
Pre-amp
Noise Figure at rated Gain
7,5
Booster with mid-tage
In-Line with mid-tage
Pre-Amplifier
High Power Booster
High Power Booster with mid-tage
High Power In-line
High Power In-line with mid-tage
Input Dynamic Range
Input/Output Isolation (Min)
Gain Flatness at Specified Gain with GFF
Optical Return Loss (at Input and Output ports)
Polarization Mode Dispersion
µs
+/-0.5
+/-1.0
Polariziation Dependent Gain
Transient Overshoot (10 dB Drop)
Transient Suppression Time (10 dB Drop)
Management
WDM transmission laser status,Temperature status,
Port reception status, Port transmission status
LEDs
Monitoring
Alarm
Input power, Output power, Gain,Temperature
Input power, Output power,Temperature
Power Consumption:
18dBm type
High Power
Model dependent - see ordering information section
WDM & Optical Transport
EM800-OAIM
Optical In Line Amplifier with Mid-stage +17dbm output and 20db gain
EM800-OAIM25
EM800-OAI
Optical In Line Amplifier with Mid stage +17dbm output and 25db gain
Optical In Line Amplifier + 18dbm output and 20db gain
EM800-OAP
Optical Pre-Amplifier + 13dbm output and 20db gain
EM800-OAP10
EM800-OAB
Optical Pre-Amplifier +13 dbm output and 10db gain
Optical Booster Amplifier + 18dbm output and 9db gain
EM800-OABM
EM800-SOAIM
EM800-SOAI
EM800-SOAI25
EM800-OAI25
Optical Booster Amplifier with Mid-stage +17dbm output and 9db gain
Single channel Optical in line Amplifier with Mid-stage +13dbm output and 20db gain
Single channel Optical in line Amplifier output +13dbm output and 20db gain
Single channel Optical in line Amplifier output +17dbm output and 25db gain
Optical In Line Amplifier +18dbm output and 25db gain
EM800-SOAP
EM800-SOAB
EM1600-OAIM
EM1600-OAI
Single channel Optical Pre - Amplifier +13dbm output and 20db gain
Single channel Optical Booster Amplifier +18dbm output and 15db gain
Single channel Optical Booster Amplifier +13dbm output and 15db gain
Optical Booster Amplifier with Mid-stage +17dbm output and 9db gain
Optical In Line Amplifier with Mid-stage +17dbm output and 20db gain
Optical In Line Amplifier +18 dbm output and 20db gain
EM1600-OAP
Optical Pre-Amplifier +13 dbm output and 20db gain
EM1600-OAP10
EM1600-OAB
Optical Pre-Amplifier +13 dbm output and 10db gain
Optical Booster Amplifier +18 dbm output and 9db gain
EM1600-SOAIM
EM1600-SOAI
Single channel Optical in line Amplifier with Mid-stage + 13dbm output and 20db gain
Single channel Optical in line Amplifier + 13dbm output and 20db gain
Single channel Optical Pre-Amplifier + 13dbm output and 20db gain
Single channel Optical Booster Amplifier + 18dbm output and 15db gain
Single channel Optical Booster Amplifier + 13dbm output and 15db gain
EM1600-SOAP
EM1600-SOAB
EM1600-SOAB13
High Power EDFAs
EM800-OAI21P
EM800-OAB22P
EM800-OAB22PM
EM800-SOAB22P
EM1600-OAB22P
EM1600-OAB22PM
EM1600-OAI21P
EM1600-OAI21PM
EM1600-SOAB22P
Optical In Line Amplifier with +21dbm output and 20db gain
Optical In Line Amplifier with Mid-stage +21dbm output and 20db gain
Optical In Line Amplifier with Mid-stage +21dbm output and 25db gain
Optical Booster Amplifier with +22dbm output and 9db gain
Optical Booster with Mid-stage+22dbm output and 9db gain
Single channel Optical Booster Amplifier +22dbm output and 20db gain
Optical Booster Amplifier with +22dbm output and 9db gain
Optical Booster Amplifier with Mid-stage +22dbm output and 9db gain
Optical In Line Amplifier with +21dbm output and 20db gain
Optical In Line Amplifier with Mid-stage +21dbm output and 20db gain
Single channel Optical Booster Amplifier + 22dbm output and 20dB gain
MRV-LD-OA
Rev.5 11-09
Copyright ©2008 MRV Communications, Inc. All Rights Reserved.
相关型号:
©2020 ICPDF网 联系我们和版权申明