W31-X2M1G-25 [MACOM]
Toggle or Push/Pull Actuator Thermal P and B Circuit Breaker; 切换或推/拉热器P和B断路器
| 型号： | W31-X2M1G-25 |
| 厂家： | 
Tyco Electronics |
| 描述： | Toggle or Push/Pull Actuator Thermal P and B Circuit Breaker |
| 文件： | 总3页 (文件大小：101K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
Catalog 1308242
Issued 3-03 (PDF Rev. 12-08)
W23/W31series
Toggle or
Push/Pull Actuator
Thermal P&B Circuit Breaker
W23
W31
Features
Maximum Resistance vs. Current Rating @ +25°C
• 0.5 amp to 50 amp ratings may be used as on/off switch.
• Cannot be reset against overload.
• W23 has visible trip indicator band.
• Screw termination.
Current
Rating
in Amps
Maximum
Resistance
in Ohms 30%
1
5
.61
.03
• Trip-free operation.
10
15
20
30
40
50
.01
.006
.004
.003
.002
.002
Agency Approvals
W23 and W31 are UL 1077 Recognized as Supplementary Protectors.
File E69543, and CSA Accepted as Supplementary Protectors
(Appliance Component Protectors), File LR15734.
Users should thoroughly review the technical data before selecting a product part
number. It is recommended that users also seek out the pertinent approvals files of
the agencies/laboratories and review them to ensure the product meets the
requirements for a given application.
Electrical Data @ +25°C
Calibration: Will continuously carry 100% of rating, may trip between
101% and 134% of rating at 25°C. Must trip at 135% in
one hour.
Maximum Operating Voltages: 50VDC or 240VAC (to 400 Hz).
Interrupting Capacity:
Mechanical/Environmental Data
Endurance Cycling: More than 6,000 cycles at 100% of rating, or 10,000
mechanical cycles.
Humidity: Will meet requirements of MIL-STD-202, Method 106.
Salt Spray: Will meet requirements of MIL-STD-202, Method 101, Test
Condition B.
With 4X Max. Series Fuse Protection
Termination: Two #8-32 screw terminals.
0.5-50 amp models — 1000 amps at 240VAC.
30-50 amp models — 1000 amps at 50VDC.
Without 4X Max. Series Fuse Protection
0.5-25 amp models — 2000 amps at 50VDC.
10-20 amp models — 2000 amps at 120VAC.
Resettable Overload Capacity: Ten times rated current.
Dielectric Strength: Over 1,500 volts RMS.
Mounting: W23 — Threaded bushing, 3/8” (9.53mm) diameter.
W31 — Threaded bushing, 15/32” (11.91mm) diameter, with or
without anti-rotation flats.
Weight: Less than 2 oz. (57g).
Time Vs. Current Trip Curve @ +25°C
Ambient Compensation Chart
1.40
1000
(A) All 5-50 Amp Models
(B) All 0.5-4 Amp Models
1.30
1.20
1.10
1.00
0.90
0.80
0.70
0.60
Overload
Trip Times
Overload
Trip Times
900
800
700
600
500
400
300
200
100
0
100%
135%
200%
400%
600%
800%
1000%
No Trip
Trip in 1 hour
6.0-22 Sec.
1.0-3.0 Sec.
0.45-1.5 Sec.
0.3-0.8 Sec.
0.25-0.6 Sec.
100%
135%
200%
400%
600%
800%
1000%
No Trip
Trip in 1 hour
11-30 Sec.
2.0-8.0 Sec.
1.0-5.5 Sec.
0.6-4.0 Sec.
0.4-2.5 Sec.
(A)
(B)
–20 –10
0
10 20 30 40 50 60
Ambient Temperature In Degrees Centigrade (°C)
To use this chart: Read up from the ambient
temperature to the curve, and across to find a correction
factor. Multiply the breaker rating by the correction factor
to determine the compensated rating. Calculate the
overloads in terms of the compensated rating to use the
published trip curve.
.1
1
10
Time In Seconds
100
1000
Dimensions are shown for
reference purposes only.
Dimensions are in inches over
(millimeters) unless otherwise
specified.
Specifications and availability
subject to change.
www.tycoelectronics.com
Technical support:
Refer to inside back cover.
116
Catalog 1308242
Issued 3-03 (PDF Rev. 12-08)
Ordering Information
B
Typical Part No.
W
23
-X
1
A
1
G
-5
1. Designator:
W = Circuit breaker
2. Series Number:
23 = Single pole, push/pull
3. Circuit Function:
X = Series trip
4. Button:
1 = Black with white amp rate marking and white trip band.
5. Mounting Bushing:
A = 3/8”-24 threaded bushing .375” (9.53mm) long, silver color
6. Terminals (See drawings for relative terminal positions):
1 = Screw terminals situated 90° to each other with #8-32 screws and washers installed.
3 = Screw terminals situtated parallel to each other pointing upward with #8-32 screws and washers installed.
7. Mounting Hardware:
A = Knurled nut/hex nut installed
G = Two hex nuts/lockwasher installed
Z = No mounting hardware supplied
8. Amp Rating:
0.5
1
3
4
5
7.5
10
15
20
25
30
35
40
50
2
Stock Items – Authorized distributors are more likely to stock the following items.
W23-X1A1G-1
W23-X1A1G-2
W23-X1A1G-3
W23-X1A1G-5
W23-X1A1G-7.50
W23-X1A1G-10
W23-X1A1G-15
W23-X1A1G-20
W23-X1A1G-25
W23-X1A1G-30
W23-X1A1G-35
W23-X1A1G-40
W23-X1A1G-50
Ordering Information
B
Typical Part No.
W
31
-X
2
M
1
G
-5
1. Designator:
W = Circuit breaker
2. Series Number:
31 = Single pole, toggle actuator
3. Circuit Function:
X = Series trip
4. Mounting Bushing:
1 = 15/32”-32 threaded bushing .320” (8.13mm) long, round, silver color
2 = 15/32”-32 threaded bushing .320” (8.13mm) long, double “D”, silver color
5. Toggle:
M = Silver color metal toggle, round, with amp rate marking on end
6. Terminals (See drawing for relative terminal positions):
1 = Screw terminals situated 90° to each other with #8-32 screws and washers installed.
5 = Screw terminals situated parallel to each other pointing downward with #8-32 screws and washers installed.
7. Mounting Hardware:
A = Knurled nut/hex nut intalled
G = Two hex nuts/lockwasher installed
Z = No mounting hardware supplied
8. Amp Rating:
0.5
1
3
4
5
7.5
10
15
20
25
30
35
40
50
2
Stock Items – Authorized distributors are more likely to stock the following items.
W31-X2M1G-1
W31-X2M1G-2
W31-X2M1G-3
W31-X2M1G-5
W31-X2M1G-7.50
W31-X2M1G-10
W31-X2M1G-15
W31-X2M1G-20
W31-X2M1G-25
W31-X2M1G-30
W31-X2M1G-35
W31-X2M1G-40
W31-X2M1G-50
Dimensions are shown for
reference purposes only.
Dimensions are in inches over
(millimeters) unless otherwise
specified.
Specifications and availability
subject to change.
www.tycoelectronics.com
Technical support:
Refer to inside back cover.
117
Catalog 1308242
Issued 3-03 (PDF Rev. 12-08)
W23 Outline Dimensions
Terminal Style 1
Terminal Style 3
.046
(1.17)
#8-32 SCREWS
WITH WASHERS
RESET BUTTON IN “ON” POSITION
WHITE INDICATOR NOT VISIBLE
.690
(17.53)
3/8-24 THREADED BUSHING
45°
45°
AMP RATING
.250
(6.35)
.56
(14.2)
.56
(14.22)
1.384
(35.15)
.315 Dia.
(8.00)
5
0.9
(2.29)
.46
(11.7)
.03MAX.
(.76)
.388
(9.86)
.570
(14.48)
1.600
(40.64)
1.890
inches
(mm)
All dimensions are given as
.046
(1.17)
(48.01)
2.035
(51.69)
Mounting Hardware
Suggested Mounting Holes
Lockwasher
(88-006B - Silver Color)
Knurled Nut
(55-008A - Silver Color)
Hex Nut
(55-001D - Silver Color)
ALTERNATE TEETH TWISTED
IN OPPOSITE DIRECTIONS
STRAIGHT KNURL
.562
(14.27)
.562
(14.27)
.375-.386
(9.53-9.80)
.078
(1.98)
.018
(.46)
.085
(2.16)
.545 – .567
(13.84 – 14.40)
W31 Outline Dimensions
Terminal Style 1
Terminal Style 5
#8-32 SCREWS
WITH WASHERS
.03 MAX
(.76)
.690
AMP RATING
(17.53)
15/32-32 THREADED BUSHING
“ON”
POSITION
45°
.09
(2.3)
.46
(11.7)
5
1.384
(35.15)
30°
REF.
.56
(14.2)
.56
(14.2)
.335
(8.51)
45°
“OFF”
POSITION
1.600
(40.64)
.380
(9.65)
ANTI-ROTATION
FLATS
.625
(15.88)
.046
(1.17)
.046
(1.17)
2.035
(51.69)
Mounting Hardware
Suggested Mounting Holes
Hex Nut
Lockwasher
Knurled Nut
(55-001B - Silver Color)
(88-002B - Silver Color)
(55-010B - Silver Color)
ALTERNATE TEETH TWISTED
IN OPPOSITE DIRECTIONS
STRAIGHT KNURL
.635
(16.13)
.470
(11.94)
.470
(11.94)
.600
(15.24)
.125
(3.18)
.018
(.46)
.385
(9.78)
.078
(1.98)
.545 – .567
(13.84 – 14.40)
Dimensions are shown for
reference purposes only.
Dimensions are in inches over
(millimeters) unless otherwise
specified.
Specifications and availability
subject to change.
www.tycoelectronics.com
Technical support:
Refer to inside back cover.
118
相关型号：
©2020 ICPDF网 联系我们和版权申明