2S4A_2405S1.5U [GAPTEC]
2W - Single Output - Fixed Input - Isolated & Unregulated;型号: | 2S4A_2405S1.5U |
厂家: | GAPTEC |
描述: | 2W - Single Output - Fixed Input - Isolated & Unregulated |
文件: | 总3页 (文件大小:1309K) |
中文: | 中文翻译 | 下载: | 下载PDF数据表文档文件 |
2S4A_1.5UP Series
2W - Single Output - Fixed Input - Isolated & Unregulated
DC-DC Converter
2 Watt
Efficiency up to 82%
Small footprint
Industry standard pinout
The 2S4A_1.5UP Series are designed for application where isolated out-
Internal SMD construction
High power density
No external component
required
put is required from a distributed power system..
Short circuit protection (SCP)
Temperature Range:
-40°C to +85°C
These products apply to:
1) Where the voltage of the input power supply is fixed
(voltage variation ≤ 10ꢀ)
1.5KVDC isolation
RoHS compliance
2) Where isolation is necessary between input and output
(isolation voltage ≤1500VDC)
3) Where regulated and low ripple noise is not required.
Such as: digital circuits, low frequency analog circuits.
Common specifications
Output specifications
Short circuit protection*:
Continuous, automatic recovery
2S4A_2405S1.5U: 1s
Item
Test condition
Min
Typ
10
Max
1.2
Units
Output voltage
accuracy
See tolerance envelope
graph
Temperature rise at full load:
Cooling:
25°C MAX, 15°C TYP
Free air convection
-40°C~+85°C
Line regulation
Load regulation
For Vin change of 1ꢀ
10ꢀ to 100ꢀ full load
ꢀ
ꢀ
Operation temperature range:
Storage temperature range:
Storage humidity range:
Lead temperature range:
Case material:
-55°C ~+125°C
Output voltage
accuracy
See tolerance envelope graph
< 95ꢀ
Temperature drift
Ripple & noise*
100ꢀ full load
0.03 ꢀ/°C
300°C MAX, 1.5mm from case for 10 sec
Plastic [UL94-V0]
20MHz Bandwidth
75
150
mVp-p
KHz
Switching frequency
100
Switching frequency
Full load, nominal input
100KHz TYP, 300KHz MAX
*Ripple and noise tested with “parallel cable” method. See detailed operation
instructions at DC-DC Application Notes.
MTBF:
>3,500,000 hours
1.8g
Weight:
EMC specifications
* Supply voltage must be discontinued at the end of short circuit duration for
2S4A_2405S1.5U.
EMI
EMI
EMS
CE
CISPR22/EN55022
CLASS B
(External Circuit Refer to EMC recommended circuit)
RE
CISPR22/EN55022 CLASS B
(External Circuit Refer to EMC recommended circuit)
Input specifications
ESD
IEC/EN61000-4-2 Contact 8KV perf. Criteria B
Item
Test condition
Min
Typ
Max
Units
Input current
(full load/no load)
• 5V input
• 24V input
506/23
105/6
-/60
-/30
mA
mA
Example SIP4 Case:
2S4A_0505S1UP
Reflected ripple
current
15
mA
2= 2 Watt; S4= SIP4; A= Pinning; 5Vin; 5Vout; S= Single Output;
1.5= 1.5kVDC; U= Unregulated Output; P= Short Circuit Protection (SCP)
Surge voltage
• 5V input
• 24V input
-0.7
-0.7
9
30
VDC
VDC
Input filter
Hot plug
Filter capacitor
Unavailable
Note:
1. Operation under minimum load will not damage the converter; However, they
may not meet all specification listed, and that will reduce the life of product.
2. All specifications measured at TA=25°C, humidity<75ꢀ, nominal input voltage
and rated output load unless otherwise specified.
Isolation specifications
3. Only typical models listed, other models may be different, please contact our
technical person for more details.
Item
Test condition
Min
Typ
20
Max
Units
VDC
Isolation voltage
Tested for 1 minute and 1500
1mA max
Isolation resistance
Test at 500VDC
1000
MΩ
pF
Isolation capaci-
tance
Part Number
Input Voltage [V]
Output Voltage
[VDC, Nominal]
Current
[mA, Max]
Efficiency
[%, Typ]
Switching Frequency
[KHz, Typ]
2S4A_0505S1.5UP
2S4A_2405S1.5U
5
5
5
400
400
79
79
65
24
100
Page 1 of 3
2S4A_1.5UP – Rev. 2017-1.5
Specifications subject to change without notice.
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
2S4A_1.5UP Series
2W - Single Output - Fixed Input - Isolated & Unregulated
Typical characteristics
Efficiency
2S4A_0505S1.5UP
2S4A_0505S1.5UP
Typical application circuit
If it is required to further reduce input and output ripple, a filter capaci-
tor may be connected to the input and output terminals, see Fig. 1.
Moreover, choosing a suitable filter capacitor is very important, start-up
problems may be caused if the capacitance is too large. Under the
condition of safe and reliable operation, the recommended capacitive
load values are shown in Table 1.
Figure 1
Page 2 of 3
2S4A_1.5UP – Rev. 2017-1.5
Specifications subject to change without notice.
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
2S4A_1.5UP Series
2W - Single Output - Fixed Input - Isolated & Unregulated
EMC recommended circuit
Output load requirements
When using, the minimum load of the module output should not be less
than 10ꢀ of the nominal load. In order to meet the performance para-
meters of this datasheet, please connect a 10ꢀ dummy load in parallel
at the output end, the dummy load is generally a resistor. Please note
that the resistor needs to be used in derating.
Mechanical dimensions
Note:
Unit: mm[inch]
Pin section tolerances: 0.10mm[ 0.004inch]
General tolerances: 0.25mm[ 0.010inch]
Page 3 of 3
2S4A_1.5UP – Rev. 2017-1.5
Specifications subject to change without notice.
GAPTEC-Electronic GmbH & Co. KG
sales@gaptec-electronic.com – www.gaptec-electronic.com
相关型号:
SI9130DB
5- and 3.3-V Step-Down Synchronous ConvertersWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135LG-T1-E3
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9135_11
SMBus Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9136_11
Multi-Output Power-Supply ControllerWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130CG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130LG-T1-E3
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9130_11
Pin-Programmable Dual Controller - Portable PCsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137DB
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9137LG
Multi-Output, Sequence Selectable Power-Supply Controller for Mobile ApplicationsWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
SI9122E
500-kHz Half-Bridge DC/DC Controller with Integrated Secondary Synchronous Rectification DriversWarning: Undefined variable $rtag in /www/wwwroot/website_ic37/www.icpdf.com/pdf/pdf/index.php on line 217
-
VISHAY
©2020 ICPDF网 联系我们和版权申明