ADB-FILTREX-F [GAMEWELL-FCI]

Analog PE Smoke Sensor for Harsh Environments; 模拟PE烟雾传感器适用于恶劣环境
ADB-FILTREX-F
型号: ADB-FILTREX-F
厂家: GAMEWELL-FCI BY HONEYWELL    GAMEWELL-FCI BY HONEYWELL
描述:

Analog PE Smoke Sensor for Harsh Environments
模拟PE烟雾传感器适用于恶劣环境

传感器
文件: 总2页 (文件大小:116K)
中文:  中文翻译
下载:  下载PDF数据表文档文件
Velociti™ Series  
ASD-FILTREX-F  
Description  
Harsh Environment Analog Addressable  
Photoelectronic Smoke Sensor  
The Gamewell-FCI Velociti™ Series, ASD-FILTREX-F  
photoelectronic analog addressable smoke sensor pro-  
vides early warning smoke sensing in harsh environments  
where traditional smoke sensors are impractical.  
The ASD-FILTREX-F sensor combines traditional smoke  
photoelectronic sensing technology with a unique smoke  
sampling system. A small intake fan draws air and smoke  
into the sensing chamber where a filter removes airborne  
contaminants and water mist from the air. Two (2), high  
density filters remove particulate as small as 25 microns.  
One filter can be removed for field cleaning, while the sec-  
ond filter is permanent and provides sensor protection dur-  
ing cleaning. The fan cycles on and off in a 15% duty cycle  
to increase service life and reduce current consumption.  
The air delivery system is fully supervised, with internal  
circuitry to detect a clogged filter, fan failure, loss of power  
or communications. If a filter clogs, the user is alerted to  
service the unit. Power-up is automatic when the unit is  
cleared.  
ASD-FILTREX-F  
Features  
Suited for harsh environments.  
High performance filter removes particulate of 25  
microns.  
Compatible with most Gamewell-FCI analog address-  
able series fire control panels.  
Bicolor LEDs flash green whenever the sensor is  
The Velociti™ Series use a communication protocol that  
substantially increases the speed of communication  
between the sensors and certain Gamewell-FCI analog  
addressable fire alarm controls. These devices operate in  
a grouped fashion. If one of the devices in the group has a  
status change, the panel’s microprocessor stops the group  
poll and concentrates on the single device. The net effect  
is response speed up to five times greater than earlier  
designs.  
addressed, and light steady red on alarm.*  
Note: Only the red LED is operative in panels that do not operate  
in Velociti™ mode.  
Ordering Information  
Model  
Description  
This feature allows the sensor to sense smoke while  
remaining unaffected by dust, dirt or occasional water  
over-spray encountered in hostile environments, which  
otherwise would create nuisance alarms or “very dirty”  
indications in regular analog sensors. The rugged con-  
struction makes the sensor resistant to water spray where  
occasional hosing-down cleaning is performed.  
ASD-FILTREX-F Analog PE Smoke Sensor for Harsh  
Environments  
ADB-FILTREX-F Sensor Base, Flanged  
RF-FTX  
Replacement filters/caps for detector  
(6-pack)  
An ISO 9001-2000 Company  
SIGNALING  
FM  
MEA  
Approved  
APPROVED  
Velociti™ and E3 Series™ are trademarks of Honeywell International Inc.  
S1913  
3023594 219-02-E Vol.VI 07272-0694:263  
GAMEWELL-FCI  
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118  
©2007 Honeywell International Inc. All rights reserved.  
Specifications are for information only, are not intended for installation pwurpwoswes,.ganadmareeswubejecllt-tofcchia.cngoemwithout notice. No responsibility is assumed by Gamewell-FCI for their use.  
9020-0621 Rev. C1 page 1 of 2  
Description (Continued)  
Specifications  
While providing a solution for many hostile environments,  
the ASD-FILTREX-F is not considered applicable for use  
in corrosive, hazardous or explosive areas or conditions  
exceeding the ambient conditions specified in the table.  
Sensitivity is tested via a magnet placed against the hous-  
ing per the Installation Instructions.  
Operating Voltage:  
Standby Current  
(SLC):  
Alarm Current (SLC): .007 A  
Current (Auxiliary):  
15 - 32 VDC  
.00036 A  
.006 A standby,  
.060 A checking for smoke,  
.080 A when checking for airflow.  
Operating/Installation  
Temperature:  
32° to 120° F (0 to 49° C)  
Operating Humidity: 10 to 93% (non-condensing)  
Dimensions:  
4 1/2” H x 4” W x 1 1/4”  
(11.4 x 10.1 x 3.2 cm)  
GAMEWELL-FCI  
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118  
9020-0621 Rev. C1 page 2 of 2  
www.gamewell-fci.com  

相关型号:

ADB-FL

Low Profile Analog Laser Sensor
GAMEWELL-FCI

ADB1000RE

Epoxy Molded Precision Wirewound Axial Terminals
OHMITE

ADB1004

10 AMP SILICON BRIDGE RECTIFIERS
DEC

ADB1006

10 AMP SILICON BRIDGE RECTIFIERS
DEC

ADB1008

10 AMP SILICON BRIDGE RECTIFIERS
DEC

ADB1200PCN/A+

Other/Special/Miscellaneous Converter
ETC

ADB1200PCN/B+

Other/Special/Miscellaneous Converter
ETC

ADB1504P

15 AMP SILICON BRIDGE RECTIFIERS
DEC

ADB1506

15 AMP SILICON BRIDGE RECTIFIERS
DEC

ADB1506P

15 AMP SILICON BRIDGE RECTIFIERS
DEC

ADB1508

15 AMP SILICON BRIDGE RECTIFIERS
DEC

ADB1508P

15 AMP SILICON BRIDGE RECTIFIERS
DEC