MCDHN-04F-V [ETC]
JACK SCREWS - SCREW LOCK ACCESSORIES;
| 型号： | MCDHN-04F-V |
| 厂家： | 
ETC |
| 描述： | JACK SCREWS - SCREW LOCK ACCESSORIES |
| 文件： | 总4页 (文件大小：201K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
REVISIONS
PART NO.
ECN # REV
DESCRIPTION
RELEASED
DRAWN DATE CHECKD DATE
APPRVD
DATE
-
A
DIL Switch - MCDHN Series
14/01/12
14/01/12
28/01/12
SN
JAG
Dimensions : Millimetres
Important Notice : This data sheet and its contents (the "Information") belong to the mem-
DRAWING TITLE:
TOLERANCES:
DRAWN BY:
SN
CHECKED BY:
JAG
DATE:
14/01/12
DATE:
bers of the Premier Farnell group of companies (the "Group") or are licensed to it. No
licence is granted for the use of it other than for information purposes in connection with
the products to which it relates. No licence of any intellectual property rights is granted. The
Information is subject to change without notice and replaces all data sheets previously sup-
plied. The Information supplied is believed to be accurate but the Group assumes no
responsibility for its accuracy or completeness, any error in or omission from it or for any
use made of it. Users of this data sheet should check for themselves the Information and
the suitability of the products for their purpose and not make any assumptions based on
information included or omitted. Liability for loss or damage resulting from any reliance on
the Information or use of it (including liability resulting from negligence or where the Group
was aware of the possibility of such loss or damage arising) is excluded. This will not oper-
ate to limit or restrict the Group's liability for death or personal injury resulting from its negli-
gence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.
Jack Screws - Screw Lock Accessories
ELECTRONIC FILE
UNLESS OTHERWISE
SPECIFIED,
REV
SIZE
DWG NO.
DIMENSIONS ARE
FOR REFERENCE
PURPOSES ONLY.
14/01/12
M10002506
A
(F)NHDS-V_1_DWG
A
APPROVED BY:
DATE:
SCALE: NTS
U.O.M.: mm (Inches)
SHEET:
1
OF
2
28/01/12
REVISIONS
PART NO.
ECN # REV
DESCRIPTION
RELEASED
DRAWN DATE CHECKD DATE
APPRVD
DATE
-
A
DIL Switch - MCDHN Series
02/01/12
16/01/12
16/01/12
SN
Jagan
Specifications:
Operation
Storage
Mechanical Life Operation Force
Stroke
Temperature
Temperature
1,000 cycles
500 gf
9
-40°C to +85°C
-40°C to +85°C
Electrical:
Non-switching
Rating
Contact
Insulation
Dielectric
Strength
300 V ac / 1
minute
Electrical Life
Switching Rating
Circuit
SPST
Resistance
Resistance
100 mΩ maximum 100 MΩ minimum
1,000 cycles
100 mA, 50 V dc 25 mA, 24 V dc
at initial
(at 500 V dc)
Material:
Base
: Nylon high-temp. thermoplastic
: Black
Color
Cover
Color
: Nylon high-temp. thermoplastic
: Black
Actuators
Color
: LCP high-temp. thermoplastic
: White
Contact
Terminal
Tape
: Alloy copper with gold plated
: Brass with gold plated
: KAPTON
Important Notice : This data sheet and its contents (the "Information") belong to the mem-
bers of the Premier Farnell group of companies (the "Group") or are licensed to it. No
licence is granted for the use of it other than for information purposes in connection with
the products to which it relates. No licence of any intellectual property rights is granted. The
Information is subject to change without notice and replaces all data sheets previously sup-
plied. The Information supplied is believed to be accurate but the Group assumes no
responsibility for its accuracy or completeness, any error in or omission from it or for any
use made of it. Users of this data sheet should check for themselves the Information and
the suitability of the products for their purpose and not make any assumptions based on
information included or omitted. Liability for loss or damage resulting from any reliance on
the Information or use of it (including liability resulting from negligence or where the Group
was aware of the possibility of such loss or damage arising) is excluded. This will not oper-
ate to limit or restrict the Group's liability for death or personal injury resulting from its negli-
gence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.
DRAWING TITLE:
TOLERANCES:
DRAWN BY:
DATE:
02/01/12
DATE:
Ashok
Jack Screws - Screw Lock Accessories
ELECTRONIC FILE
UNLESS OTHERWISE
SPECIFIED,
CHECKED BY:
Veena
REV
SIZE
DWG NO.
DIMENSIONS ARE
FOR REFERENCE
PURPOSES ONLY.
16/01/12
M10002506
A
(F)NHDS-V_1_DWG
A
APPROVED BY:
DATE:
SCALE: NTS
U.O.M.: mm (Inches)
SHEET:
2
OF
2
16/01/12
REVISIONS
PART NO.
ECN # REV
DESCRIPTION
RELEASED
DRAWN DATE CHECKD DATE
APPRVD
DATE
-
A
DIL Switch - MCDHN Series
02/01/12
16/01/12
16/01/12
SN
Jagan
Soldering Process:
Cleaning:
•
•
•
•
•
•
Only tape sealed types apply to wash process.
Do not remove the tape before wash process.
After soldering process, do not continue the wash process immediately. Please wait for at least 3 minutes.
Apply alcoholic solvents as cleaning agent do not use other solvents or water.
Ultrasonic cleaning is not recommended.
The cleaning process per stage is maximum. 1 minute and the whole cleaning time are not to exceed 3 minutes.
Any flux enters the switch may fall the conductivity.
Reflow Temperature Profile: (reference)
Important Notice : This data sheet and its contents (the "Information") belong to the mem-
DRAWING TITLE:
TOLERANCES:
DRAWN BY:
Ashok
CHECKED BY:
Veena
DATE:
bers of the Premier Farnell group of companies (the "Group") or are licensed to it. No
licence is granted for the use of it other than for information purposes in connection with
the products to which it relates. No licence of any intellectual property rights is granted. The
02/01/12
Jack Screws - Screw Lock Accessories
ELECTRONIC FILE
UNLESS OTHERWISE
Information is subject to change without notice and replaces all data sheets previously sup-
plied. The Information supplied is believed to be accurate but the Group assumes no
responsibility for its accuracy or completeness, any error in or omission from it or for any
use made of it. Users of this data sheet should check for themselves the Information and
the suitability of the products for their purpose and not make any assumptions based on
information included or omitted. Liability for loss or damage resulting from any reliance on
the Information or use of it (including liability resulting from negligence or where the Group
was aware of the possibility of such loss or damage arising) is excluded. This will not oper-
ate to limit or restrict the Group's liability for death or personal injury resulting from its negli-
gence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.
DATE:
SPECIFIED,
REV
SIZE
DWG NO.
DIMENSIONS ARE
FOR REFERENCE
PURPOSES ONLY.
16/01/12
M10002506
A
(F)NHDS-V_1_DWG
A
APPROVED BY:
DATE:
SCALE: NTS
U.O.M.: mm (Inches)
SHEET:
3
OF
2
16/01/12
REVISIONS
PART NO.
ECN # REV
DESCRIPTION
RELEASED
DRAWN DATE CHECKD DATE
APPRVD
DATE
-
A
DIL Switch - MCDHN Series
14/01/12
14/01/12
28/01/12
SN
JAG
Specification Table
Description
No. of Positions
Dimensions A
Part Numbers
Switch, DIP, SMD, 2 Way
Switch, DIP, SMD, 4 Way
Switch, DIP, SMD, 6 Way
Switch, DIP, SMD, 8 Way
Switch, DIP, SMD, 10 Way
2
4
3.77 (0.148)
6.31 (0.248)
8.85 (0.348)
11.39 (0.448)
13.93 (0.548)
MCDHN-02F-V
MCDHN-04F-V
MCDHN-06F-V
MCDHN-08F-V
MCDHN-10F-V
6
8
10
Part Number Explanation
MC
-
DHN
-
F
V
02
-
Soldering
V = Lead Free Solderable
F = The Actuator in “Off” Position for Delivery
Number of Positisions:
02 = 2 Positions
= Half Pitch DIP Switch
www.element14.com
www.farnell.com
(Terminal Length 6.7 mm)
Number of Positions:
www.newark.com
04 = 4, 06 = 6, 08 = 8 and 10 = 10 Positions
Important Notice : This data sheet and its contents (the "Information") belong to the mem-
DRAWING TITLE:
TOLERANCES:
DRAWN BY:
SN
CHECKED BY:
Jagan
DATE:
14/01/12
DATE:
bers of the Premier Farnell group of companies (the "Group") or are licensed to it. No
licence is granted for the use of it other than for information purposes in connection with
the products to which it relates. No licence of any intellectual property rights is granted. The
Information is subject to change without notice and replaces all data sheets previously sup-
plied. The Information supplied is believed to be accurate but the Group assumes no
responsibility for its accuracy or completeness, any error in or omission from it or for any
use made of it. Users of this data sheet should check for themselves the Information and
the suitability of the products for their purpose and not make any assumptions based on
information included or omitted. Liability for loss or damage resulting from any reliance on
the Information or use of it (including liability resulting from negligence or where the Group
was aware of the possibility of such loss or damage arising) is excluded. This will not oper-
ate to limit or restrict the Group's liability for death or personal injury resulting from its negli-
gence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012.
Jack Screws - Screw Lock Accessories
ELECTRONIC FILE
UNLESS OTHERWISE
SPECIFIED,
REV
SIZE
DWG NO.
DIMENSIONS ARE
FOR REFERENCE
PURPOSES ONLY.
14/01/12
M10002506
A
(F)NHDS-V_1_DWG
A
APPROVED BY:
DATE:
SCALE: NTS
U.O.M.: mm (Inches)
SHEET:
4
OF
2
28/01/12
相关型号：
©2020 ICPDF网 联系我们和版权申明