VPLD48J3E-100.00MHZ [CONNOR-WINFIELD]
LVPECL Output Clock Oscillator, 100MHz Nom;
| 型号： | VPLD48J3E-100.00MHZ |
| 厂家： | 
CONNOR-WINFIELD CORPORATION |
| 描述： | LVPECL Output Clock Oscillator, 100MHz Nom |
| 文件： | 总2页 (文件大小：188K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
HTTP://WWW.CONWIN.COM
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
3.3V SURFACE MOUNT VCXO OSCILLATOR
CW 0701
VPLD48J3E
100.00M
ABSOLUTE MAXIMUM RATINGS
PARAMETER
TABLE 1.0
NOTE
UNITS
MINIMUM NOMINAL MAXIMUM
UNITS
°C
Storage Temperature
Supply Voltage
-40
-0.5
-0.5
-
-
-
85
7.0
7.0
(Vcc)
(Vc)
Vdc
Vdc
Control Voltage
VPLD48J3E
OPERATING SPECIFICATIONS
PARAMETER
TABLE 2.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
DESCRIPTION
100
Center Frequency
(Fo)
-
360
-
MHz
ppm
Total Frequency Tolerance
Operating Temperature Range
Supply Voltage
-35
-
35
1
The Connor-Winfield
-30
-
70
°C
VPLD48J3E is a 3.3V Voltage
Controlled Crystal Oscillator
(VCXO) with LVPECL
Differential outputs. The
VPLD48J3E is designed for
use with PLL systems
requiring low jitter and tight
stability.
(Vcc)
(Icc)
3.135
3.3
-
3.465
Vdc
Supply Current
-
-
-
-
-
-
-
-
-
100
mA
Jitter (BW=10Hz to 20MHz)
Jitter (BW=12kHz to 80MHz)
SSB Phase Noise at 10Hz offset
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
SSB Phase Noise at 10KHz offset
SSB Phase Noise at 100KHz offset
SSB Phase Noise at 1 MHz offset
-
5
1
-
ps rms
ps rms
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
-
-50
-80
-110
-135
-140
-145
-
-
-
-
-
INPUT CHARACTERISTICS
PARAMETER
TABLE 3.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
Vdc
ppm
%
Control Voltage Range
Absolute Pull Range (APR)
Monotonic Linearity
(Vc)
0.3
+/-50
-10
-
1.65
3.0
-
-
2
FEATURES
-
10
Input Impedance
50K
-
Ohm
KHz
Vdc
Vdc
3.3V OPERATION
-
-
-
Modulation Bandwidth (3dB)
Enable Input Voltage (Low)
Disable Input Voltage (High)
10
-
1.68
-
(Vil)
-
3
3
LVPECL DIFFERENTIALOUTPUTS
ENABLE / DISABLE FUNCTION
LOW JITTER <1pS RMS
(Vih)
2.275
LOW VOLTAGE PECL OUTPUT CHARACTERISTICS
TABLE 4.0
NOTE
4
PARAMETER
MINIMUM NOMINAL MAXIMUM
UNITS
Ohms
Vdc
LOAD
-
2.275
-
-
-
50
-
TOTALFREQUENCY TOLERANCE:
±35ppm
Voltage
(High)
(Low)
(Voh)
(Vol)
-
1.68
55
Vdc
Duty Cycle at 50% Level
45
50
%
TEMPERATURE RANGE: -30 to 70°C
SURFACE MOUNT PACKAGE
TAPEAND REEL PACKAGING
PACKAGE CHARACTERISTICS
TABLE 5.0
Package
Non-hermetic package consisting of an FR4 substrate with grounded metal
cover.
PROCESS RECOMMENDATIONS
Solder Reflow
TABLE 6.0
The component solder used internal to this device has a m elting point of
221°C. The peak temperature inside the device should be less than or
equal to 220°C for a maximum of 10 seconds
ORDERING INFORMATION
Wash
Notes
Ultrasonic cleaning is not recommended.
VPLD48J3E - 100.00MHz
1.0
Inclusive of calibration @ 25°C, frequency stability vs. temperature, s upply and load variations, shock, vibration and aging
for ten years. Control voltage (Vc) = 1.65 Vdc.
2.0
3.0
4.0
Control voltage for (Fo) = 1.65 Vdc Typical. Positive Transfer Func tion.
When oscillator is disabled the true output is in a low state (Vol) and the complementary output is in the high stat e (VoH)
50 ohm termination into Vcc-2V or Thevein equivalent.
VCXO
SERIES
CENTER
FREQUENCY
Specifications subject to change without notice.
12/18/03
Vx499
1
2
01
REV:
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
DATE:
a
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
HTTP://WWW.CONWIN.COM
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
Pin Function
1
2
3
4
5
6
Control Voltage
Enable / Disable
Ground (Case)
Output Q
Comp Output Q
Vcc
Dimensional Tolerance:
±.005” (.127mm)
80%
50%
20%
2
1.65V
E/D
Specifications subject to change without notice.
12/18/03
Vx499
01
2
2
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
REV:
DATE:
a
相关型号：
©2020 ICPDF网 联系我们和版权申明