ASOF3S3P [CONNOR-WINFIELD]
3.3V SURFACE MOUNT STRATUM 3 PLUS HCMOS OCXO; 3.3V表面安装的Stratum 3 PLUS HCMOS OCXO
| 型号： | ASOF3S3P |
| 厂家： | 
CONNOR-WINFIELD CORPORATION |
| 描述： | 3.3V SURFACE MOUNT STRATUM 3 PLUS HCMOS OCXO |
| 文件： | 总2页 (文件大小：189K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
CW 0540
ASOF3S3P
10.00M
3.3V SURFACE MOUNT STRATUM 3
PLUS HCMOS OCXO
ABSOLUTE MAXIMUM RATINGS
PARAMETER
TABLE 1.0
NOTE
UNITS
MINIMUM NOMINAL MAXIMUM
UNITS
Storage Temperature
-40
-
-
85
°C
Supply Voltage
(Vcc)
-0.5
4.5
Vdc
ASOF3S3P
OPERATING SPECIFICATIONS
PARAMETER
TABLE 2.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
MHz
ppm
ppm
ppm
ppm
ppb/day
ppm
ppm
°C
DESCRIPTION
9.00
20.00
Center Frequency
(Fo)
-
Frequency Calibration
-0.30
-
0.30
1
2
3
4
Frequency vs. Change in Temperature
Frequency vs. Change in Supply Voltage
Frequency vs. Change in Load
Frequency Aging Daily
-0.21
-
0.21
The Connor-Winfield
-0.05
-
0.05
ASOF3S3P is a surface
mount, 3.3V Oven Controlled
Crystal Oscillator (OCXO)
with a HCMOS / TTL
compatible output. The
ASOF3S3P is designed for
higher frequency stability
Stratum 3 Plus applications
requiring low jitter and tight
frequency calibration.
-0.02
-
0.02
-
-
8
Frequency Aging per year
Total Frequency Tolerance
Operating Temperature Range
Supply Voltage
-0.5
-
0.5
-1.5
-
1.5
5
0
-
70
(Vcc)
(Icc)
(Icc)
3.13
3.30
3.47
Vdc
Supply Current
-
-
450
mA
Supply Current Steady State @25°C
Allan Variance (1 second)
Phase Jitter (10Hz to 20 MHz)
Period Jitter
-
180
-
-
mA
-
5.00E-10
-
-
1
3
-
ps RMS
ps RMS
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
Minutes
ppm
-
-
-70
-100
-125
-140
-150
-
SSB Phase Noise at 1Hz offset
SSB Phase Noise at 10Hz offset
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
SSB Phase Noise at 10KHz offset
Warm Up Time
-
-
-
-
-
-
-
-
-
-
5
0.3
1
2
6
7
FEATURES
Retrace
-0.3
-
TDEV @ 1.0 Sec.
-
-
-
nS
TDEV @ 4.0 Sec.
-
nS
3.3V OPERATION
HCMOS OUTPUT CHARACTERISTICS
PARAMETER
TABLE 3.0
NOTE
LOW JITTER<1pS RMS
MINIMUM NOMINAL MAXIMUM
UNITS
pf
LOAD
12
2.6
-
15
-
18
-
FREQUENCY STABILITY ±0.21ppm
TEMPERATURE RANGE: 0 to 70°C
Voltage
Current
(High)
(Low)
(High)
(Low)
(Voh)
(Vol)
(Ioh)
(Ioh)
Vdc
Vdc
mA
mA
%
8
8
-
0.4
-
-4
-
-
50
-
4
OVERALL FREQUENCY TOLERANCE :
±1.5ppm over Twenty Years.
Duty Cycle at 50% of Vcc
45
-
55
6
Rise / Fall Time 10% to 90%
nS
SURFACE MOUNT PACKAGE
TAPEAND REEL PACKAGING
PACKAGE CHARACTERISTICS
Package
TABLE 4.0
Surface Mount, Non-hermetic package consisting of an FR4 substrate with
grounded metal cover.
PROCESS RECOMMENDATIONS
TABLE 5.0
The component solder used internal to this device has a melting point of
221°C. The peak temperature inside the device should be less than or equal
to 220°C for a maximum of 10 seconds
Solder Reflow
Wash
Ultrasonic cleaning is not recommended
ORDERING INFORMATION
Notes:
1) Initial calibration @ 25°C at time of shipment.
2) Frequency vs. temperature stability, 0 to 70°C absolute.
3) Frequency stability per 5% change in supply voltage.
4) Frequency stability per 5% change in load
ASOF3S3P - 10.00MHz
5) Inclusive of calibration, operating temperature range, supply voltage change, load change, shock
and vibration and aging over 20 years.
OCXO
SERIES
CENTER
FREQUENCY
6) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.5ppm of nominal.
7) 24 hours off then 60 minutes on at a constant temperature and voltage.
8) Supply voltage at 3.3 Vdc.
Specifications subject to change without notice.
11/09/05
Cx059
1
2
03
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
REV:
DATE:
a
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
ENVIRONMENTAL CHARACTERISTICS
Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 20 cycles,10 minute dwell, 1minute
transition.
SOLDERING
Pad Solderability: Per MIL-STD-883, Method 2003. 8 hour steam age prior to 245°C ±5°C Solder pot dip, 95%
Coverage.
Solder Reflow: The component solder internal to this device has a melting point of 221°C, the peak temperature inside the
device should be less than or equal to 220°C for a maximum of 10 seconds.
MECHANICAL CHARACTERISTICS
Vibration: Per MIL-STD-202, Method 204, Condition A. 10G’s peak, 10Hz to 500Hz, 15minute cycles 12 times each
perpendicular axis.
Shock: Per MIL-STD-202, Method 213, Condition D. 500G’s, 1ms, halfsine, 3 shocks per direction.
Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65°C, 10 cycles 10°C to 65°C.
OUTPUT WAVEFORM
Pin
1
Connection
N/C
90%
50%
10%
7
8
14
Ground (Case)
Output
Vcc
SUGGESTED PAD LAYOUT
..333300 mmaaxx
((88..338822mmmm))
Dimensional Tolerance:
±.005 (.127mm)
KEEP OUT AREA
.830
(21.08mm)
.565
(14.35mm)
Specifications subject to change without notice.
11/09/05
Cx059
03
2
2
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
REV:
DATE:
a
相关型号：
ASOF3S3P-FREQ
HCMOS Output Clock Oscillator, 9MHz Min, 20MHz Max, SURFACE MOUNT PACKAGE-14
CONNOR-WINFIE
ASOF5S3-FREQ
HCMOS Output Clock Oscillator, 1.544MHz Min, 20MHz Max, METAL PACKAGE-14/4
CONNOR-WINFIE
©2020 ICPDF网 联系我们和版权申明