ATAM893S [ATMEL]
MARC4 4-bit Microcontrollers; MARC4 4位微控制器
| 型号： | ATAM893S |
| 厂家： | 
ATMEL |
| 描述： | MARC4 4-bit Microcontrollers |
| 文件： | 总3页 (文件大小：44K) |
| 中文： | 中文翻译 | 下载： | 下载PDF数据表文档文件 |
DI Errata
• ATAM893S
• ATAM894P
• ATAR092P
• ATAR892P
• ATAR090H
• ATAR890H
• ATAR080F
• ATA6020N
• ATAR510F
• ATAR862N3/N4/N8
MARC4 4-bit
Microcontrollers
ATAM893S
ATAM894P
ATAR092/892P
ATAR090/890H
ATAR080F
The latest product enhancement (PCN HC030703 DI enhancement) introduced to all
MARC4 products during 2003, leads, under some conditions, to an unforeseen and
unwanted behavior. The circuit may not process interrupts correctly. All above men-
tioned MARC4 products are affected.
Description
If a DI command is immediately followed by a CALL or SCALL command and an inter-
rupt meets this DI command, this interrupt is kept in the interrupt active register
permanently despite a correct RTI execution. Even if the EI command in the inter-
rupted program has been executed, this bit in the interrupt active register stays set
and disables the execution of any interrupt of the same or lower priority. Only an inter-
rupt with a higher priority or a reset is able to solve this blocking status.
ATA6020N
ATAR510F
ATAR862N3/4/8
If the command following the DI is a NOP, the interrupt active register usually is
cleared correctly after an RTI and executing interrupts then continues normally.
Errata Sheet
Rev. 4813A–4BMCU–06/04
Workaround
MTP Parts
a) Experienced customers using Atmel MTP parts (ATAM893S, ATAM894P) can modify the
HEX-file directly. Within each interrupt service routine, replace the HEX-code for CCR! in front
of the RTI with a SCALL to a free address. Introduce the HEX-codes for the commands LIT_1,
OR, CCR! and EXIT at this address. Now, with each RTI, the interrupt enable flag is set. This
software modification overrides the last hardware modification, i.e., the parts behave as if not
having received DI-enhancement, and the interrupt active register will be cleared correctly.
b1) An equivalent modification can be done in the source code, but the modification depends
on the content the compiler saved at the beginning of an interrupt service routine:
0080
: INT1
0080 0D
0081 73
0082 72
CCR@
Y@
X@
\$SAVEREG
In this case, CCR, X and Y registers were saved, therefore, the modification should look as
follows:
2>R 2>R 1 or 2R> 2R>
either at the beginning or at the end of the interrupt service routine.
b2) If only CCR and one of the registers were saved:
01E0
:INT7
01E0 0D
01E1 73
CCR@
Y@
\$SAVEREG
The modification looks as follows:
ROT 1 or <ROT
c) Customers using MTP parts may switch their order to the predecessor version.
Customers using ROM parts may switch their order to the predecessor version.
ROM Parts
Up to now it has not occurred, that parts working correctly under all conditions might fail in the
future or under different environmental conditions.
2
MARC4 4-bit Microcontrollers Errata Sheet
4813A–4BMCU–06/04
Atmel Corporation
Atmel Operations
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 487-2600
Memory
RF/Automotive
Theresienstrasse 2
Postfach 3535
74025 Heilbronn, Germany
Tel: (49) 71-31-67-0
Fax: (49) 71-31-67-2340
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 436-4314
Regional Headquarters
Microcontrollers
2325 Orchard Parkway
San Jose, CA 95131, USA
Tel: 1(408) 441-0311
Fax: 1(408) 436-4314
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906, USA
Tel: 1(719) 576-3300
Europe
Atmel Sarl
Route des Arsenaux 41
Case Postale 80
CH-1705 Fribourg
Switzerland
Tel: (41) 26-426-5555
Fax: (41) 26-426-5500
Fax: 1(719) 540-1759
Biometrics/Imaging/Hi-Rel MPU/
High Speed Converters/RF Datacom
Avenue de Rochepleine
La Chantrerie
BP 70602
44306 Nantes Cedex 3, France
Tel: (33) 2-40-18-18-18
Fax: (33) 2-40-18-19-60
BP 123
38521 Saint-Egreve Cedex, France
Tel: (33) 4-76-58-30-00
Fax: (33) 4-76-58-34-80
Asia
Room 1219
Chinachem Golden Plaza
77 Mody Road Tsimshatsui
East Kowloon
Hong Kong
Tel: (852) 2721-9778
Fax: (852) 2722-1369
ASIC/ASSP/Smart Cards
Zone Industrielle
13106 Rousset Cedex, France
Tel: (33) 4-42-53-60-00
Fax: (33) 4-42-53-60-01
1150 East Cheyenne Mtn. Blvd.
Colorado Springs, CO 80906, USA
Tel: 1(719) 576-3300
Japan
9F, Tonetsu Shinkawa Bldg.
1-24-8 Shinkawa
Chuo-ku, Tokyo 104-0033
Japan
Tel: (81) 3-3523-3551
Fax: (81) 3-3523-7581
Fax: 1(719) 540-1759
Scottish Enterprise Technology Park
Maxwell Building
East Kilbride G75 0QR, Scotland
Tel: (44) 1355-803-000
Fax: (44) 1355-242-743
Literature Requests
www.atmel.com/literature
Disclaimer: Atmel Corporation makes no warranty for the use of its products, other than those expressly contained in the Company’s standard
warranty which is detailed in Atmel’s Terms and Conditions located on the Company’s web site. The Company assumes no responsibility for any
errors which may appear in this document, reserves the right to change devices or specifications detailed herein at any time without notice, and
does not make any commitment to update the information contained herein. No licenses to patents or other intellectual property of Atmel are
granted by the Company in connection with the sale of Atmel products, expressly or by implication. Atmel’s products are not authorized for use
as critical components in life support devices or systems.
© Atmel Corporation 2004. All rights reserved.
Atmel® and combinations thereof are the registered trademarks of Atmel Corporation or its subsidiaries.
Other terms and product names may be the trademarks of others.
Printed on recycled paper.
4813A–4BMCU–06/04
相关型号：
©2020 ICPDF网 联系我们和版权申明